Models > GCE23LBWAFWW > Instructions

GCE23LBWAFWW General Electric Refrigerator - Instructions

Jump to:

All Instructions for the GCE23LBWAFWW
76 - 90 of 197
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Ronald from GROVELAND, FL
Parts Used:
WR02X10821
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Slide control was broken
Simply slide new control slide through slot from front.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Vincent from TUCSON, AZ
Parts Used:
WR14X10059
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
replace seal on crisper drawer
spent 10 minutes trying to clip in the seal without any success. I emptied the crisper drawer and removed it flipped it over clipped the seal. replaced the drawer. Secret is to remove the drawer from the refrigerator.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Daniel from LK HOPATCONG, NJ
Parts Used:
WR71X10761
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Broken self insert
It clips right in
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Silvia from KANSAS CITY, MO
Parts Used:
WR71X10761
Difficulty Level:
A Bit Difficult
Total Repair Time:
Less than 15 mins
Broken shelf insert
It was a bit hard to pop it into place.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Barbara from MOUNT VERNON, IL
Parts Used:
WR71X10973
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
The bottom was cracked
Just replaced it with new part
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Lynn from RCH PALOS VRD, CA
Parts Used:
WR71X10761
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
My shelf inserter broke into pieces.
It was very easy to install and fit right into the shelf.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
David from NORTH PALM BEACH, FL
Parts Used:
WR24X10155
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
door gaskets developed mold which could not be removed
out with the old
in with the new
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
joseph from DEERFIELD BCH, FL
Parts Used:
WR71X10761
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
dont know what you are talking about
i did not buy any part from you company. you do not state what it was i bought. i purchase a lot of items on line and they always tell me what the item is.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
James from NEW YORK, NY
Parts Used:
WR02X10540
Difficulty Level:
Easy
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Pliers, Screw drivers, Socket set
noisy refrigerator
I followed your video and completely dismantled the refrigerator evaporator motor, fan, brackets, and grommet, I completely cleaned the refrigerator including the cooling coils. I then ordered the evaporator motor ,fan, grommets, lid bumper, and brackets. The order would take a week to arrive. In the meantime I cleaned and reassembled all the old parts, waiting for the new ones to come. Guess what! The refrigerator was quiet as a mouse. I really did not need the new parts, but I kept them anyway just for good luck. Not bad for a refrigerator that's twenty four years old.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Michael from WOODINVILLE, WA
Parts Used:
WR49X10091
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Screw drivers
Fridge too cold. Couldn't get it above 31F
The video was very helpful as the fridge used was close in configuration to ours. Only difficulty was installing the light tray assembly which on ours is two piece, a U shaped plastic tray into which the light assembly/electrical harness is attached. Re assembly was tricky as the plastic tray was flimsy and the light assembly kept coming out. Needed two pairs of hands but not enough room. The problem was solved by using blue tape to keep the complete assembly together, then gently removing it after the 4 mounting screws were in place. After that all went smoothly. Turns out the old damper assembly was broken. Since then the fridge has been working normally with set temp. of 37 holding steady and freezer at 0, per GE recommendations. Good fix!!
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Matthew from Escondido, CA
Parts Used:
WR02X12008
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
Fan making noise.
Remove ice maker and all of it's accessories in order to remove the panel covering the fan. Don't drop the screws!
Unscrew the lower fan bracket. You will see the lower red rubber grommet. Hold fan motor with one hand and push the fan off the shaft and into the compartment above. Then remove the round retainer thing below it by holding it and pulling down on the motor assembly. Install new grommet on upper part. and put it all together.
REMEMBER where the fan is on the shaft. It has about one inch of shaft placement. I put mine so that most of it was above the hole that the fan goes into and about 20 percent showing below the sheet metal.
Also check to see if your fan is damaged. Mine was not.
This refrigerator has been awesome! I have had many issues but have been able to fix all of them for the last 15 years!
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Trevor from ALAMOGORDO, NM
Parts Used:
WR60X10307
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers
Motor stopped due to corrosion
Uncovering the motor is the most difficult part. Installation is stupid-easy. Put all of the coverings back on in reverse order to the way they were removed. I don't think the ice maker has to come out but we weren't using it so it came out first.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
James from GREENSBORO, NC
Parts Used:
WR02X12008
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Socket set
Fan was not centered in the middle of the back panel opening.
Bent the motor bracket down, then using a rat tail file, elongated the holes in the back panel of the refrigerator to secure the fan in the "centered" position. This was a problem that was with the refrig. since it was made. The parts involved were perfect. NO problem at all installing them.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Kyle from HAZEL GREEN, AL
Parts Used:
WR49X10091
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
Refrigerator made EVERYTHING Frozen; Water line was frozen; Ice machine stopped working
This part worked marvelously. I followed a YouTube video to completion. Essentially, I removed the water filter cover by squeezing the tabs on the side. Then, I removed the housing for the light based on the tabs placement. I unscrewed the lighting fixture, unplugged and set aside. After that, I removed the bottom part of the damper assembly (that's not included but virtually attached to the damper) by pulling on its tabs' placements. Then, I pulled off the damper assembly, unplugged the cords and added the new assembly WITH the inclusion of the damper gasket assembly that doesn't seem to have been a part of the old assembly. Rescrewed and reattached everything and now the fridge is as good as new!!!
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
ron from QULIN, MO
Parts Used:
WR49X10091
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
Fridge side was getting to cold
Found this site on the web. Told them my problem. They told me the most common part failure. I purched the part. Installed it per instructions. Waaa la now have a working refrigerator thank so much. U got the wife happy
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the GCE23LBWAFWW
76 - 90 of 197