WRS22PRBW0 Frigidaire Refrigerator - Instructions

First time we ever ordered parts on the internet and we were very happy when the item arrived because it came within three days, now that is SERVICE and it fit perfectly! Thank you for the effecient process.

First we took the the old drawer out and pride off the front clear covering on both sides. Then we placed the front covering on the new drawer and fit it in place. This had to be done twice since it did not take the first time. It had come loose after a couple of days and we snaped it back into place. It has done fine since.

Removed old drawer. Removed front face of drawer and installed on new drawer. Put new drawer in refridgerator.

My husband just dislodged the front of the old drawer and very carefully slipped it into the new drawer. Presto all fixed. Very easy. So happy with the new drawer that is so easy to slide open. We had taped the old one for quite a few years. Wish I would have thought of looking up this web-site earlier! Thank you so much for this new drawer!!

I received the drawer within 2 days of ordering it online, which was extraordinary. I removed the front of the old drawer, as instructed and placed it on the new drawer. I then replaced the drawer in the refrigerator and the job was complete. The entire experience from beginning to end was simple and completed in very little time. Had I known it would be this easy, I would have ordered the drawer sooner.

I removed old drawer. Then I removed the front face panel. I had to wedge the knife in the front bottom so I could remove the face. Installed face on new drawer. Inserted new drawer in fridge.
Voila ! Works great.

The end cap is easy to remove and replace. The personnel at PartSelect was extremely helpful in re-ordering the correct part.

Just removed the two screws and unpluged it.
Then I pluged the new one in and replaced the screws. It runs like a brand new reffrigerator.
Thanks for the fast delevery. Will do busness with you in the future.

I took my time to remove the front off of the old drawer,by gently prying it apart with two screwdrivers, this was the hardest part, the front installed very easily . The shippiong time was 2 days instead of three. Will use partselect again.

I didn't know the front of the drawer could come off so it was pretty gunked up with dried meat juices that had leaked. The fit was very tight. I had to really work the putty knife to get it between the front and the drawer at the bottom where the catch is. I was afraid I would break or chip the front before I got it off but it handled the pressure pretty well. Had to use some force though. Once I cleaned the front it slid right down and snapped into place.

take 1/4 hex screws out clean out dust ,remove old fan blade replace with new install bolts .

First I removed the old drawer front. When put the old front onto the new drawer I noticed that the two little rubber plugs had nowhere to push into as the holes were not drilled out. I got my portable drill and drilled out the holes, then I slid the drawer front into place snapped it in and pushed in the plugs.

Website was great!

The defrost timer was right in front. 2 minutes and a screwdriver and I had it replaced.

To replace the thermostat, I had to take out the back panel, defrost it and then install the new part. the only problem was that the heatshrink tubing they sent was too large. Otherwise, it worked great.

took 4 screws out of the discharge vent on top of the refrigerator section and unpluged the wiring harness and put the section on the counter and unscrewed the timer and put the new one in and reinstalled the assembly and plugged the Jack and put the 4 screws back in, and rotated the timer and put it on defrost removed the back and check the heaters and drain .

The job was as simple as could be pry away the old and push in the new.
Only wish I had done years ago. Tthis is a great service to customers.