F45PR22CW0 Frigidaire Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- M from Louisville, KY
- Parts Used:
- 5303289500
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken track on upper storage drawer
No tools required! Easy as falling off a log! Drawer face snaps off and reinstalls on new drawer body; slide it in track and you're good to go.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- LUIS from CENTENNIAL, CO
- Parts Used:
- 215846602
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Freezer built ice, fridge not cold enough and running constantly.
Removed front low grill, removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the wires. Reversed process to install new timer.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- LK from LAWRENCE, KS
- Parts Used:
- 5303289501
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
broken rail inserts that hold the drawer up and in place
Moved glass front from broken drawer and placed on new drawer
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Joachim from Marengo, AL
- Parts Used:
- 5303289501
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
refr. shelf had been damaged and glueing would not work permanently
Just snap the ordered part to the undamaged front part together.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dan from Lakewood, CO
- Parts Used:
- 5303289500
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
drawer had broken side rails
I removed old drawer. Then I removed the front face panel. I had to wedge the knife in the front bottom so I could remove the face. Installed face on new drawer. Inserted new drawer in fridge.
Voila ! Works great.
Voila ! Works great.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from Tampa, FL
- Parts Used:
- 5303289501, 5303289500
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Drawers had broken due to age
Founds parts I needed here. Customer service was very helpful. Parts arrived in very short time frame 1-4 days.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from Wesley Chapel, FL
- Parts Used:
- 5303289500
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
broken drawer
I removed old drawer, removed face plate, installed faceplate on new drawer. Test OK.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Scott from Alexandria, VA
- Parts Used:
- 5303289501
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The Bulldog grabbed the Meat and Cheese!
Lower Door in Fridge Broke and all the Meats and Cheeses came tumbling out...Bulldog grabbed a bunch of it and gobbled it down ...so I looked up the part on Wednesday and ordered it, received it on Friday (really fast without paying extra)...took out meat and cheese that was left, presssed old front piece onto new drawer and slid it into place...meat and cheese now safe from bulldog again!!! Thanks PartSelect.com!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Doris from Riverview, MI
- Parts Used:
- 5303289500
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
Broken edge on storage drawer
My husband just dislodged the front of the old drawer and very carefully slipped it into the new drawer. Presto all fixed. Very easy. So happy with the new drawer that is so easy to slide open. We had taped the old one for quite a few years. Wish I would have thought of looking up this web-site earlier! Thank you so much for this new drawer!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Barbara from Mulvane, KS
- Parts Used:
- 5303289501
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- Less than 15 mins
Side of drawer broke/chippped - hard to open.
I didn't know the front of the drawer could come off so it was pretty gunked up with dried meat juices that had leaked. The fit was very tight. I had to really work the putty knife to get it between the front and the drawer at the bottom where the catch is. I was afraid I would break or chip the front before I got it off but it handled the pressure pretty well. Had to use some force though. Once I cleaned the front it slid right down and snapped into place.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Marcus from Pine Hill, AL
- Parts Used:
- 215846602
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
frezzer iceing over and not cooling the refrigerator
Just removed the two screws and unpluged it.
Then I pluged the new one in and replaced the screws. It runs like a brand new reffrigerator.
Thanks for the fast delevery. Will do busness with you in the future.
Then I pluged the new one in and replaced the screws. It runs like a brand new reffrigerator.
Thanks for the fast delevery. Will do busness with you in the future.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- NATHANIEL from PEARLAND, TX
- Parts Used:
- 5303289500
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Top Edges Broke
Use small srew driver to take door off and put back on just like the video you supplied on line.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from Staten Island, NY
- Parts Used:
- 218015601
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
Broken Glide
Used Old Screws And a nutdriver
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- steve from Kirkland, WA
- Parts Used:
- 215846602
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
freezer worked frig was warm. Ice maker is still not working
Removed two screws to get to defrost time pull panel down remove two screws holding time and reinstall
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- EDWIN from ELWOOD, IN
- Parts Used:
- 5308000010
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver
loud noise fan blade broke,off balance
take 1/4 hex screws out clean out dust ,remove old fan blade replace with new install bolts .
Was this instruction helpful to you?
Thank you for voting!