MRS22HRAW0 Frigidaire Refrigerator - Instructions

Purchased switch and socket, not sure which had failed. Moved all frozen food to refrigerator, turned off breaker. Used nutdriver to remove two screws holding box containing switch and socket. Removed old switch and socket. Removal was slightly difficult since cabling came off both sides of the box. Installed new switch and socket and bulb. Turned breaker back on, checked light as workiing. Replaced scrrews to re-intstall switch box ( or whatever you call it ) Closed door and waited for freezer to cool. Returned all frozen food to freezer. Job Done

Followed instruction vedeo from partselect. THANKS!!!!!

Ordered the repair part. Removed the drawer. Removed front of drawer. Placed front on new drawer. Very simple.

just pulled yhe old one out and put the new on

The process was very simple, slid the front off of old drawer and slid the front on the replacement drawer.

unplugged frig,removed bottom front cover and loosend 2 screws at bottom front left and slid defrost timer out from behind metal panel,unplugged the old and plugged in the new.frig works great.

Based on the diagnosis on this site I thought the 66% odds of the problem being the Defrost Timer looked pretty good, $30 including shipping versus a Sears tech phone estimate of $250-300. BINGO! Just follow the online installation instructions and don't forget to use the reset switch as described. Works like new! THANK YOU

removed the front from the broken drawer and slipped onto the new drawer and put it back in the refrigerator. Very simple!

Problem not consistent. OK for 2-3 weeks, then freeze coils. Mark and observe the defrost timers manual rotating adjuster. Timer would stop mid cycle. One revolution equals 8 hours of compressor run time followed by 30 minutes of defrost. Replacing timer took 5 minutes.

I followed the procedure online and found the thermostat was ok, it had continuity when cold, and the heater coil was also ok, it too had continuity, therefore the problem was a bad defrost timer. the refrigerator works great, thanks parts select!

Replacement parts fit perfectly. Simply removed the broken frame, place existing glass in new frame, and set frame in back wall mounts, then lower frame to side existing side mounts. Insert new drawer in the new frame. Worked great.

Everytime I pulled out my upper storage drawer I risked having the whole thing collapse as the rims of the drawer were broken due to old age. I ordered a part and there was a terrific "how to" installation video that showed exactly what I had to do to transfer the drawer front(still in good condition)from the broken drawer to the new one. The whole process took less that ten minutes. However, be warned: when ordering parts do not assume that the model number you first try is correct if you receive a notice that it is not available---1's and I's and zeros and O's are easily confused. I ordered the wrong-sized part the first time by using the wrong #'s/letters; replacement was quick and easy, but, naturally, I had to pay for return postage. Service from this company is great--almost next day delivery!

You guys at Partselect are the best!!! Went to your site, typed in my appliance symptoms, and received possible fixes. Ordered the suggested parts (under $50) on a Sunday night and got em Tuesday am. Installed the easiest one first and Voila!!!! Frig is working great. Thanks Bob S

Remove 4 screws that hold up overhead controls, this is also the part that holds the light. Unplug the timer and replace. Super simple and runs great now. After you plug it in it may take a few minutes to kick on the compressor but it will. Also I was pleased it was a factory Frigidare part. Price was right.

I used a pick to remove the lugs from the old starter. Clicked them right in the new one and it went to woking!!!