MRS22HRAW0 Frigidaire Refrigerator - Instructions

The end cap is easy to remove and replace. The personnel at PartSelect was extremely helpful in re-ordering the correct part.

take 1/4 hex screws out clean out dust ,remove old fan blade replace with new install bolts .

just like the video showed...it was excellent!!!

The job was as simple as could be pry away the old and push in the new.
Only wish I had done years ago. Tthis is a great service to customers.

took 4 screws out of the discharge vent on top of the refrigerator section and unpluged the wiring harness and put the section on the counter and unscrewed the timer and put the new one in and reinstalled the assembly and plugged the Jack and put the 4 screws back in, and rotated the timer and put it on defrost removed the back and check the heaters and drain .

The instructions given to me by part Select were very good.I replaced the Timer- checked the heater with oham meter it was good- checked the door weather striping it was good and replaced the thermostat with new .So at this point I may need to call a professional unless some one has another solution.

I watched the video you had on-line and it was simple. Thank you so much

The replacement of the Drawer Cover support was simple, it snapped in to the existing holes. You had said you did not have a replacement for the crisper drawer cover but the storage drawer cover was identical and I ordered it, and snapped the adjustable vent off of the old crisper onto the new storage drawer cover and all was well. The parts arrived in two days without expedited shipping. I couldn't be happier.

The ordering process was great and the package with the upper and lower drawers arrived on time. I watched the video and was ready to go. I loosened the front of the drawer as instructed, but I couldn't get it off. Finally I realized that the front was "glued on" by the accumulation of years of use. I sprayed it with 409 and the two separated just like they were supposed to. The rest of the process went easy -- just like the video said. When I changed the second drawer, I sprayed it fist and the process was really simple. Thanks for your service and for your instruction video.

Ordered the new part-Unplugged the refrigerator - took off the cover over the defective timer - put in the new part put the cover back on - plugged the refrigerator back in - so far, so good!~

Took out the broken one, cleaned the frigi, guided the new frame into the mounting hole. It's was very easy and the help video really helped: both for finding the right part and once the parts arrived, step by step procedure.Thank you.

Unplug the refrigerator. Removed the right hand top shelf. Used a 1/4" nutdriver to remove rear center mounting screw for Control Housing. Used Phillips screwdriver to remove two mounting screws for timer. Unplug cable from timer and plug it into the new timer. Install the new timer and re-install the Control Housing. Plug in the refrigerator and adjust the timer to start the unit. This was a snap with the diagnostic provided by Part Select. At first I thought it was the fan rubbing but when I removed the cover (two screws) it was obvious that wasn't the problem. The diagnostic hinted that it was either the timer or the motor capacitor making the noise. Because the noise continued after turning OFF the control, I thought it was the timer...I was right.

Simply removed drawer from refrigerator, slide the front door off old drawer, wash new drawer & old door, slide door into place on new drawer and replace in fridge.

Removed broken pieces and installed new parts. The web site schematic was very helpful in ordering the proper part. Very easy!

Removed the lower trim panel from front of fridg. and loosened two screws enough to turn it about 1/4 inch so the screw heads were in the larger holes. Pulled it out disconnected the wire connector and transfered the heat shield and screws to the new clock, connected the wire connector and aligned the screws. tightened them and job done. Has worked like new sense. Thanks Roger