GLVC25V7FB2 Frigidaire Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Joel W from LAUGHLIN, NV
- Parts Used:
- 240351061
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Old crisper drawer cracked
Took out old drawer. Removed clips from that drawer in rear and clipped onto new. Removed humidifier control from old and inserted into new. Slid drawer onto track.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from PHILADELPHIA, PA
- Parts Used:
- 5303918202
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
Evaporator was freezing up and was running non stop
I tested the components in the refrigerator defrost function. I used digital multimeter and checked for continuity. Defrost thermostat must 32 degrees or lower.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Frank from HOWELL, NJ
- Parts Used:
- WF2CB
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Slow water output
Followed easy instructions
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lynn from NESCOPECK, PA
- Parts Used:
- 240351061
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Cracked crisper
Pulled out the old-put in the new.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Nancy from ROGERS, AR
- Parts Used:
- 240350649
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
While washing the insert, I dropped and broke it.
Ordered the correct part according to the specifications; took the packing plastic off; and placed it on the crisper. Ta Ta!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Olga from ALEXANDRIA, IN
- Parts Used:
- WF2CB
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
filter just needed to be changed.
I pushed the button on the filter holder to release the filter by pushing it out of the holder pulled it out all the way and put the new one in. The whole prosses took five seconds.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Salvador from SANTA ANA, CA
- Parts Used:
- 5303918202
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Pliers
Freezer worked, refrigerator didn't. Ice build up on coils.
Unplugged refrigerator. Emptied freezer and removed ice maker and cover, need to unplug fan. Defrosted coils with hot water. Cut wires to thermostat as close to it ad possible to leave extra wire in case of an error. Stripped wire in new thermostat and put in shrink plastic then the wire crimp connector joining both light blue wires making sure wires were in before crimping them. Repeated with other dark blue wire. After used the heat gun to shrink the protective white tubing. The only thing i found not satisfying was tge tubing. It was too wide and too small. When i shrunk it did not cover the whole connector and was loose. I had to use a glue gun to cover both ends of each wire connector. Hope this helps other users.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Anthony from BOILING SPGS, SC
- Parts Used:
- 240328203
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Wrench (Adjustable)
Popping noise from lower hinge bearing of door.
Easily removed the refrigerator door, layed it across a table, popped out the lower hinge bearing and lightly tapped in the new one. Reinstalled the door and adjusted alignment. Popping noise gone.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from MONTGOMERY, IL
- Parts Used:
- 5303918202
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Socket set
Coils frozen over. Refrigerator not cooling
I cut wires from bad thermostat and removed it . Stripped wires and crimped connectors on new thermostat and wires from old thermostat. Used heat gun to seal sleeves over connectors. Very helpful video from this site Thanks, you will be my go to parts supplier from now on!!!!!!!!!!!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Nathaniel from Mastic, NY
- Parts Used:
- 5304520331, 5303918455
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Socket set
Right door wasn't closing right
Emptied everthing on the RT.Remove upper guard and hinge,lift door off of lower hinge.Set it down somewhere safe.Remove lower hinge,replace with New Hinge,Door part # 5303918455, Closer Bushing part #240457702. Put the back on the frige,Boom done.."Miller Time" [or whatever You prefer} I had this problem before,and I see Frigidaire upgraded the hinge and the Plastic Bushing..Thank You
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Suzanne from TAVARES, FL
- Parts Used:
- 240599803
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
broken shelf holder
You pop the old frame out, take out the glass, slide the new frame in and reinstall the shelf. No tools required. Very easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Cecil from CYNTHIANA, KY
- Parts Used:
- 5303918455
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Socket set, Wrench set
Hinge plastic closer broke
Watched the video on YouTube and followed the instructions.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Donald from WEIRTON, WV
- Parts Used:
- 241885001
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Socket set
Plastic gate to redirect ice to the crusher broken off
Removed ice maker bin...removed screws and housing and reinstalled all...very easily completed.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Brad from Corning, NY
- Parts Used:
- 240328203
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Socket set
After opening (and closing) just past halfway , refrigerator door made a very loud "clunk" noise.
Empty contents of refrigerator door (trust me!). Gently pop off top door hinge plastic cover. Remove two top hinge bolts. Lift door up and off lower hinge pin and place on a towel on a flat surface. Grab the lower hinge cam with pliers and pull out. Mine wasn't broke like others have written, but it was clearly worn. Slide the new cam into place and rehang door in reverse order. Instant fix. 15 minutes work. If I had known how easy and effective the repair was going to be, I would have replaced the freezer side as well because it is just starting to get a little "clunky" noise to it. Thank you PartSelect!
Was this instruction helpful to you?
Thank you for voting!
Broken Crisper drawer cover and support
Removed broken parts and installed new ones. Only had a little problem getting supports out. I think they had sticky stuff from spills in the refrigerator that made it more difficult.
Was this instruction helpful to you?
Thank you for voting!