SSD522SBL-P1184701WL Amana Refrigerator - Instructions

Popped the old one out with a kitchen knife and popped the new one back in. It tool less than 15 seconds!!

Took a toital of 15 minutes to exchange the bucket. A total of 4 screws to remove the auger and front of the bucket. Anyone can do this repair!!

I pried the old one out with a screw driver and pushed the new one in. I expected instructions in the box it came in but there were none.

I received my part in two days. Installation was easy. Most difficult part was attaching the inclosed metal clips onto the grill. The entire process took me 10 minutes. That included cleaning under the refridgerator. My wife said it was dusty.

Please bear in mind I am 65 years old & it was harder to get up & down off the floor then to change the switch. Was very easy - watched video, unplugged unit. I used the putty knife at the right front corner to work loose, when it came loose had to loose the left side a little. The unit pulled out easily. detached the wired that had a single plug with 2 prongs on it. Attached the plug, pushed new switch into place. There was no way you could place wires on wrong prong. When done, plugged refrigerator back in & checked if working. I CAN SEE THE LIGHT and the food in the freezer now. Thank you for making an easy repair.

I've been messing around with the old part for literally years. Every now and then the metal agitator rod would spin out of the plastic cup that joins it to the freezer. I'd have to disassemble it and try to get it back into alignment. This time nothing worked, so I ordered a new assembly. It arrived even more promptly than PartSelect predicted and it installed in five minutes. I couldn't be happier!

Called amana repair to install new part , but worker called in sick. did it myself, was easy, only one phillips head screw and part slid out. looks like a florescent light starter with a wire attached with a loop on the end.very easy and thanks to the super fast delivery..next day, i could hardly believe it...

The DIY video was very handy and precise to every visual detail needed for anyone to do their very own repair. It doesn't get any better than that.

Very easy repair just follow the instructions provided here

Replace the Auger & Crusher blade. Very easy to do and it works great now. Also, your customer service was great!! shipped the same day and arrived to me the next day!!

Simply stick a putty knife between the switch and refrig wall. Pop out old swith, remove both wires by pulling off switch by terminals. Throw switch out. Put wires on new switch and push into slot and all done. Nothing to it! Took me 5 minutes if th

I simply installed the shelf by placing the built in hooks in the door. I called the 800 number to order because I wasn't sure what the part was called. I received superb help from a real person!! The part arrived very quickly; within 2 days. I am very pleased to have the refrigerator intact again.

1)pry out the old/defective light rocker switch with a screw driver (flat head) and pull out the cables 2)unplug two connectors at the end of light rocker switch 3) connect new light rocker into two connectors 4)push the wires inside and put back new light rocker switch

I did exactly as the video showed. I popped out the old switch, disconnected the two terminals, connected the new switch and put it back. The light now works! The refrigerator is over 25 years old and the switch works! What a great website this is. Couldn't of done the job without Partselect's help.

Opened box removed Icemaker Auger and Crusher Blade Assembly (assembled). Removed Ice bucket from refrigerator, took off face cover, removed two screws at the bottom of auger assembly and removed the auger from the bucket and inserted the new one replaced the two screws. Installed the Ice bucket. Worked like a charm.