Models > ART2107BC-PART2107BC0 > Instructions

ART2107BC-PART2107BC0 Amana Refrigerator - Instructions

Jump to:

All Instructions for the ART2107BC-PART2107BC0
91 - 105 of 135
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Peter from San Jose, CA
Parts Used:
W10613606
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver, Pliers
Unit hummed, buzzed, and compressor did not run
You just take the back panel off (8 screws with hex heads), disconnect one wire harness, pull off the relay, and push on the new one. Easy peasy. Getting the wires off was the only tricky part, they clip in place so you have to pry the retaining clip loose. Unfortunately, it turns out our compressor is shot so replacing the relay did not fix the problem.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Steve from River Edge, NJ
Parts Used:
W11384469
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
exchange of defective light rocker switch
1)pry out the old/defective light rocker switch with a screw driver (flat head) and pull out the cables 2)unplug two connectors at the end of light rocker switch 3) connect new light rocker into two connectors 4)push the wires inside and put back new light rocker switch
Was this instruction helpful to you?
Thank you for voting!
Customer:
Anthony from Fairport, NY
Parts Used:
W11384469
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Light in the refrigerator didn't work
I did exactly as the video showed. I popped out the old switch, disconnected the two terminals, connected the new switch and put it back. The light now works! The refrigerator is over 25 years old and the switch works! What a great website this is. Couldn't of done the job without Partselect's help.
Was this instruction helpful to you?
Thank you for voting!
Customer:
john from Woburn, MA
Parts Used:
W10833899
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers, Socket set
The ice making got slow.I replace the ice maker in December 2012 and it marginally until it stoped completely January 2014.
The Amana You Tube video explained and demonstrated how to isolate the problem. After finding the problem I ordered the Water Valve on a Sunday and I installed it Tuesday morning in about ten minutes.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Tricia from Folsom, CA
Parts Used:
W10613606
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers
frige warm and freezer icing up
I pulled the frige out, took off the cover from the bottom with a nut driver. Took off the safety clip then pulled the plug out from the relay then the relay came out. Replaced the part and reinstalled the same way. This was really easy and fast.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Dennis from Grant, NE
Parts Used:
W10613606
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Compressor would not run.
The repair was simple. It was a matter of unpluging the old relay and then pluging in the new one. I almost bought a new refrigerator but after doing alittle reading on this web sight and finding out the most common reason for having the problem I was having I decided to order the relay. It was the problem...$ 70.00 -v- $1400.00. I'm HAPPY !
Was this instruction helpful to you?
Thank you for voting!
Customer:
Nathan from Gilbert, IA
Parts Used:
W10613606
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers
A buzzing noise coming from compressor area lasting 8-10 seconds followed by a click.
My 8 year old Maytag side-by-side started having a buzzing sound coming from the compressor area that lasted around 8 to 10 seconds which was followed by a "click" sound. It would repeat every 3 minutes or so. From what I read, the Overload/Relay with Start Capacitor was the likely culprit. I got it replaced tonight but unfortunately, the same problem is occurring. The downside is I likely have a bad compressor (not worth replacing after cost of parts and labor) and wasted $60 on the Overload/Relay with Start Capacitor. Partselect's service though I would say is top notch. I received the part within two days of placing the order and my order confirmation email even had a link to a youtube video detailing the installation. That was very helpful. I just wish I was looking at a $60 fix vs a grand for a new fridge! Oh well, live and learn....and no more Maytag.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Ramakrishna from Charlotte, NC
Parts Used:
W10613606
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers
Fridge died overnight - replaced overload cap & relay - working again
initial research suggested that relay is common failure point -opened back panel and found that relay was "truly smoked" - black soot came out when I removed it and shook it also checked that the compressor itself wasnt damaged using the resistance check across pins and also from pin to outer cover - determined that the compressor seemed OK and fault likely isolated to relay - - overload cap seemed to be ok - but decided to replace entire unit (relay and cap) - ordered on partselect.com - video showing how easy repair was very helpful - replaced it - and DONE!
Was this instruction helpful to you?
Thank you for voting!
Customer:
Joseph from North Anddover, MA
Parts Used:
W10613606
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver
Refrigerator and freezer stopped cooling. Compressor pump not coming on
I removed the cover panel. There is a clip that holds the relay and capacitor to the pump. Use a screwdriver to pry it off. Unplug the relay. The capacitor is plugged into the relay and they come together which was a surprise, I thought I only ordered the relay. Unplug a cable from the relay. Insert that cable into the new relay and plug it into the compressor. Reattach the clip. One be important instruction. Unplug the refrigerator for at least 8 hours before installation to allow the compressor to cool down. I tried first without allowing the compressor to cool and it did not work. After letting it cool I tried again and it worked like charm. Make sure the refrigerator is unplugged when doing the repair
Was this instruction helpful to you?
Thank you for voting!
Customer:
Don from Laramie, WY
Parts Used:
W11384469
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Switch didn't work
followed the video as instructed. Saved two repairman calls, one to find the problem, one to install. Net savings was about $130.00
Was this instruction helpful to you?
Thank you for voting!
Customer:
Lisa from Winlock, WA
Parts Used:
W10613606
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
Frig went dead
Looked at questions, picked one that applied, ordered suggested part, fix was super easy after watching video, Frig in running, part fixed it. Very excited, Thankyou.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jim from Bush, LA
Parts Used:
W10613606
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers
Freezer Cold/Frig Warm
One mnorning the temp on the frig was in the 50's and the freezer was cold. Tried to get someone to come out and repair with no luck. We purchased a new frig. Then I decided to see if I could repair the old one to use. I wish I had discovered partselect before I bought the new one. First I thought from the web site that it was a overload/relay problem so I ordered it and changed it out and it was very easy. Then that did not correct the problem so I checked further and discovered that it could be the defrost heat element and thermostat. On partselect web site I saw where if your coil is covered in ice that this could be the reason. I ordered them and watched the video of how to change them out. The video is a little misleading because chances are you will not have the room around the coil that it shows on the video and also the element and thermostat will not come as one unit as shown on the video. It is still easy to cut the wires ont he thermostat and install it. The heat element is a little tricky to get out and back in and the clips that holds yours might be a little different and more difficult to do than the video but you can do it. All in all I spent about 160. 00 And the frig is working like new.
Was this instruction helpful to you?
Thank you for voting!
Customer:
William from Takoma Park, MD
Parts Used:
W10613606
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
Failed overload/relay start capacitor
Apparently, the manufacturer sometimes substitutes a part but keeps the same number, which is what happened here. The part wouldn't fit in the actual space on this model--even though the number was apparently correct! Refunding my money and assisting me to contact the manufacturer directly couldn't have been easier! Impressive customer service in a difficult situation.
Was this instruction helpful to you?
Thank you for voting!
Customer:
David from St. Pete Beach, FL
Parts Used:
W11384469
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
Broke the arm off the food compartment rocker switch
After receiving the new part almost immediately,using two screw drivers, removed the broken switch from the plastic frame. Be careful not to scratch or otherwise tear the plastic...very pliable. Since the original switch was factory installed and the wires were packed in fiberglass insulation, the switch came out but the wires and clips were still in place and could not reach the new switch. It was necessary to pull them down with bent long nose pliers...used a lot of "pull" but the wires held up.Connected the switch, turned the power on and there was light! Reports from other users really took the uncertainty out of the task.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Raymond from Chicago, IL
Parts Used:
W10613606
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers, Socket set
Compressor would not start
Unplug Refrigerator remove lower back panel to expose compressor.Unplug Capactor relay assembly,Plug in new start assenbly,and then the refrigerator to elect'outlet .Compressor srarted right up . Real easy fix simple tools to perform change out. Thanks!!! Saved a bunch of $$$$$ .
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the ART2107BC-PART2107BC0
91 - 105 of 135