CRE7500ADL Maytag Range - Instructions

I watched the video intructing the installation of the bake element. The one thing I would suggest is to remove the oven door as this allows someone with a shorter reach to do the repair.

Unplugged stove. Removed door. Unfastened 2 screws at rear of oven. Removed wires from bake element. Connected new bake element. Replaced screws and door. Plugged oven back in.

Shut off electricity to appliance then unpluged wiring from old element and pluged in new element.

Removed 2 screws, should have tripped breaker first but learned the hard way, unplug wires, install new.

Removed old coil by unscrewing the element and unplugging it from the wires, adjusted the terminal slightly and plugged in the wire from the new element.

It was a very simple process and would have taken me less time if I wasn't so old and couldn't bend easily!

This is the second time I have replaced the bake element. It looks like 8 years is about as long as they last under normal use. The repair was simple; remove 2 screws, pull the bake element out, disconnect the wire connected to each end of the bake element, then reverse the process to reinstall.

Remove the bottom rack from the oven. Pull the heating element straight back and out of the oven. Inserted the replacement burner in the opposite manner. Part was delivered in a timely manner.

unscrewed the element and pulled it out, then put the new element in.

I shut the breaker off at the main power box.
In the oven, I loosened two screws to remove the old element (parts now, after the burn-out). I pulled the old element out of the back wall of the oven to expose the wire connections. I detached the simple sliding wire connectors. Done with removal. I waited for the new element to arrive (one week). Installed easily. Turned on the breaker and baked a few potatoes. Very simple.

Not really much of a repair story to tell. While using the oven one evening the baking element began sparking and appeared as someone was using an arc welder inside my oven. I went to the computer and did a search for Magic Chef parts and found the Part Select web site. There I entered the model number of my range which brought up the schematics allowing me to locate the part I needed, the baking element. On that parts page I also found a very short, concise video illustrating "how to" change out the element. I ordered the part and received it rather quickly (a matter of days.) Following the directions on the video I had the baking element swapped out in about the same amount of time as it took in the video. Could not have been any easier.

My husband unscrewed the old element and pulled out the wires and took the old element off and reconnected the new element and screwed it back in in less than five mins. Your video explained how to do it. The service was great. The price was good and it got here fast. I ordered it on Sunday and it was here by Wed.morning.

Followed the instructions exactly as described on the Parts web site video, shut off power, removed old baking element, checked connectors, replaced with new element, turned power back on to the range. Repair took less than 15 minutes.

first I took the opportunity to clean the oven really well, Turned off the electricity at the breaker box, Took out the screw on each side and pulled out to view the clips they were attached to, they came off easily, I attached the new ones pushed in to place and reattached the 2 screws. Easiest thing I've ever done and was so cost effective to do this instead of replacing the stove. Works great!I can't believe it was shipped so quickly. I will be shopping here in the future!!!

Removed back of stove (6 screws), puled clips loose. Two screws inside oven, pulled out old element. slid new one in, replaced screws, slid on clips replaced back panel. Don't forget to unplug the stove frist.

Took out 2 screws pulled off the 2 female connectors. put the conectors on the new element and put the screws in. It took less than 10 minutes