Sold individually. This surface burner grate is for ranges.
Surface burner grate provides a stable surface for cookware on the surface burner.
Wait until the surface is cool to the touch before ...
This chrome oven rack is a genuine replacement component designed to fit a variety of standard ovens. Measuring approximately 24.76 inches wide by 15.78 inches deep, it provides a stable surface for b...
This is a screw and it is made for multiple appliances in your home. This model is called a sheet metal screw because it has sharp points, and the threads are closer together. This screw is designed t...
This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, an...
This 15-watt, 120-volt light bulb is designed to illuminate the interior of wall ovens and ranges, allowing clear visibility during cooking. It serves as a direct replacement for burned-out bulbs and ...
This part is the replacement door gasket for your oven. It is now made of black rubber and is sold individually. The door gasket runs along the circumference of the oven door and creates a seal that i...
Ask our experts a question about this part and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched. Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Richard
April 3, 2024
Burners will not ignite just a clicking noise what part needed to fix?
For model number KGSS907SSS01
Hello Richard, thank you for contacting us. Based on our understanding of the issue, we would suggest replacing the spark module, part number FIX11753037, to solve the problem. We hope that helps!
Getting an error code F2E1 tried unplugging it for a minute didn't fix problem what now?
For model number KGSS907SSS01
Hello Rick, thank you for getting in touch. According to our research, the error code F2E1 means that there is a communication problem between the user interface and the control board. We would recommend first checking the switch membrane, part number FIX11747328, to fix the issue. We hope this sorts out your problem!
Something Kitchen Aid wont tell you but running a self clean on this model stove blows the fuse located on the back of the stove.
First I slid the stove out and removed the back of the stove held in place by 8 Phillips screws. The thermostat fuse is located near the top middle on the back of the stove. Remove the 2 screws hold
... Read moreing it in place. Disconnect the wires, plug in the new part. Put it all back together. Job done in less than 30 minutes.
This repair would have cost $164 through A&E factory service.
My wife used the self cleaning function for the first time after 1.5 years of owning, of course out of warranty. A quick google search identified the problem. Called Kitchenaid, they said of course it can't be that simple, they had never heard of this problem, need to schedule a service call. Googled and found this site, Ordered the part
... Read more, came in, only took a screwdriver and about 20 minutes, just like all the other posts.
shame on Kitchenaid for not owning up to the problem. I even e-mailed them all the links, they did not acknowledge them.
I just looked at the tech sheet on the range and tested the gas valve with an ohm meter to see how much resistance I had and compared it to the tech sheet and noticed the gas valve was bad. So I replaced it with a new one from part select which arrived very fast. It was quite easy to replaced it.
