62946975 Kenmore Range - Instructions

Remove cover plate, install new switch, replace cover place. Replace one wire at a time, a pair of needle nose pliers may be helpful. Surprise of this job was that I had a torque screw driver (I think that's what it's called) to remove the switch from the cover plate. These are the screws you'll see after removing the knob. Find that driver before you begin, mine was in the garage and for the life of me, I can't remember why I ever had one in the first place.
Thanks for a great web site!

First I disconnected the power at the breaker box.
Then I removed the two screws that hold the element in place. I then pulled the old element out about 3 inches and disconnected the two wires. Then connected the two wires to the new element, pushed it back into place, then fastened in place with the two holding screws. Reconnected the power and tested and all worked fine.

Just plugged them in and reset the door,.

Just great.

Replaced one of the four burner control switches on my Jennair cooktop. One of the tricks I use to prevent mistakes is putting the new switch along side the existing one and swap one connector at a time over to the new switch preventing any confusion and negating any need to mark the wires. This differs from your video assistant who disconnected all the wires at once.
gc.

Husband got on partselect.com and read reviews, we ordered a long oven sensor kit. When it came in the mail, I took it out and look at it, decided I could probably switch the part.... and so I did. Easy Breezy ... and it worked well

I've ordered parts from you twice now, and both times the service has been absolutely amazing!!!!!

Now, on to how I did this without fire or electrocution:

Turned off breakers.
Grabbed a beer.
Removed two screws holding in plate.
Removed electrical connectors.
Removed two screws holding switch.
Put new switch in place with screws.
Reattached connectors.
Reseated plate & screws.
Turned on power & tested.
Finished beer and felt very manly.

The hardest part was getting the plate to re-seat.

first I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires then I took new element and plug the wires in it pushed the element back in place and replaced the two screws

see example. that's just how it went. easy. not really worth reporting.

very easy - not really a "repair" more of a face lift, although the grill was unusable.

Parts were perfect - Used it the same night.

Removed old grease filter,replaced with new grease filter. No tools needed.
I ordered the grease filter on Tuesday and it arrived at my door on Wed.
Best experience ever ordering a part, I will definitely use Part Select again and have already recommended it to friends.

I remove fore screwsfrom the front panel. Then remove two screws to remove the switch and removed the wire plugs then put everything back together again.

I used a pair of plyers to remove both items and pushed new items in holes. Job complete

Removed two phillips head screws, pulled the element out until the prongs were exposed, pulled off the wire connectors and removed the bad element. After plugging the wires onto the new element, I pushed it back in and replaced the two screws. Easy job! Your web site is wonderful!

I turned off the breaker for the oven. Then I unscrewed the 2 screws holding the element in and pulled the element out. I unhooked the wires from the element and put the new element in. Reconected the wires, pushe it back into place and replaced the 2 screws. Turned the breaker back on and it works GREAT! Way easy!!! ...even for a girl!

First turned the breaker off. Then I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires. Reconnected the wires the new element, slid back in nd reiserted the two screws and tightened it all up. Flipped the breaker back and back in business.