Models > D-100 > Instructions

D-100 Jenn-Air Range - Instructions

Jump to:

All Instructions for the D-100
16 - 21 of 21
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Alyce from San Antonio, TX
Parts Used:
WP715269
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Element quit working
Ordered the part. It arrived in about 4 days. Took a screw driver and in just a few minutes, it was working again. BINGO
1 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Tom from Rochester Hills, MI
Parts Used:
WP715269
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
Heating coil/ element gave out.
I turned off the power first. Then I removed the element by taking out the three screws. The oven was quite old so getting the screws out took a little extra effort. Installation of the new element went easier. I was pleased with how soon the part arrived after I ordered it.
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Eugene from Satellite Beach, FL
Parts Used:
WP715269
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
Oven element burned out
The only trouble I couldn't remove the screws that held the wires to the element, so I cut the wires as close to the end as possible and attached new hardware. After that was done it was simple to reinstall the new element. Turned the power back on. Turned the oven on and it worked like new.
0 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
john from chatham, MA
Parts Used:
WP715269
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
bake element not heating up
removed element and tested wirh ohm meter. No reading telling it was bad. Tested voltage from supply wires. Voltage correct. Ordered new element which can in 2 days. Installed-tested- problem solved. 2 scres connect element.
0 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
JOSEPH from WARRENTON, VA
Parts Used:
WP715269
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
lower element was burnt out
same as your example
0 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Kelly from Gardner, KS
Parts Used:
700158
Difficulty Level:
Easy
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Pliers, Screw drivers
Replace oven thermostat
De-energized appliance power at it's circuit breaker. Removed control panel access cover. Removed control panel. Removed old thermostat and installed new thermostat. Reset control panel and access cover. Reset appliance circuit breaker. Confirmed thermostat operation.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the D-100
16 - 21 of 21