FCE30510WC Jenn-Air Range - Instructions

Removed unit from counter, removed 14 screws holding glass top to frame, removed ceramic element, swapped over mounting brackets to new element, checked wireing as per instruction sheet (direct replacement) connected wires, re-installed glass top to frame and placed back into counter. ops check good.

The hardest part was taking out original light bulb because screws on shield where hard to unscrew after all this years . The old bulb vent out leaving neck in socket. It took narrow electrical pliers to get neck out .The generic appliance bulb did not fit and had aluminum neck ,not recommended for brass sockets in ovens.Putting new light bulb in was not the problem.

Pretty simple, except the element melted very close to one end, so the screw holding the element to the rear of the stove was partly melted also. Had to drill it out & used a nut & bolt to secure the new element.
Apart from that, it was a breeze. As others have done, I re-tightened the lugs that the element plugged into.
Suggest a "test heating" before using stove: mine had a strong odor on first use, fine afterwards

Unscrewed 2 holding brackets. Removed old element. Unfortunately one clip broke off the wire and had to be replaced. Attached clips to element and replaced holding brackets.
Job is simple but working in the oven without damaging the oven door requires a younger back.
Without problems should take ten minutes.

replaced burner element

Repair went fine as I read on how to do it and it worked fine. Hardest part was hitting the hole for the screws.

Turned off the breaker to the stove. Removed the screws holding the old parts in and unplugged the element. After reshaping the element because it got damaged in shipping I plugged the wires to the new element, replaced the screws and turned the breaker back on. Tried the stove and it has worked fine since.

It would've been so much easier if replacement instructions were included. Replacement screws would've been nice also

Unscrewed two screws holding element in place and pulled off the electrical wires to the element.( be sure to remove power to the stove)Put wires on new element and installed screws back in. Done

First I turned OFF the elect power to the stove.
Then I got a flash light to see into the oven. removed the two screws, anf pulled the element out far enough to disconnect the two wires.
Put the connecters on the new element pushed it back put the two screws back.
Turned the power on works great, very easy.

Removed old coil by unscrewing the element and unplugging it from the wires, adjusted the terminal slightly and plugged in the wire from the new element.

It was a very simple process and would have taken me less time if I wasn't so old and couldn't bend easily!

First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires attached to the element, reattached to new element and replaced screws. This was very easy, I was glad I did not call the repairman.

Shut off electricity to appliance then unpluged wiring from old element and pluged in new element.

After finding out my 2nd hand electric stove was not reaching the temperature I needed to bake my cookies I knew I had to either find out what was wrong & repair it or purhcase another stove. The baking element was the culprit and it was really easy to fix. I disconnected the power line to the stove, unscrewed the old element & pulled apart the contacts from the wires. I then reversed the process and was done in less than 30 minutes. I was extremely pleased with how fast my order was shipped - I ordered the part on Tuesday & the part was waiting for me on Thursday when I got off from work. Will definitely order from PartSelect again!

Removed two screws and unpluged old element plugged in new element and re-attacheched to oven. No Problems at all.