PP258TP (TYPE 3) Poulan Pole Saw - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Steve from SALEM, OH
- Parts Used:
- 530069599
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers
Broken fuel line
Removed broken fuel line from gas tank. Threaded new line into tank routed it to the carb and cut to length needed. Attached to the carb.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Rosanne from BRIDGEWATER, VA
- Parts Used:
- 545227901
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
Clogged muffler
Remove the 4 screws holding the rear motor casing. Then you can take the easy route and drill through the front motor housing with a 3/8 to 1/2 bit in order to access the front muffler screw. If you want to work harder you must remove the motor from the shaft, remove the clutch assembly (this requires a long 15t torx bit, removing the spark plug to stuff the piston with rope or rag to seize up the piston, and then removing the front motor casing to access the front muffler screw). Once you access both muffler screws remove them with the t20 torx driver. Install the new muffler with the small gasket inside the housing, and the larger gasket/heat shield between the muffler and the motor.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Joseph from COLLEGEVILLE, PA
- Parts Used:
- 530150552
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- 30 - 60 mins
I lost the oil cap for lubing blade
I ordered new one, it took a while to arrive and I found the diameter threads were wrong, seems like a simple part to replace, guess not
Was this instruction helpful to you?
Thank you for voting!