LMV1813SB (CBKELGA) LG Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Edward from ORCHARD PARK, NY
- Parts Used:
- 6600W1K001D
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver
Door switch was burnt out
Removed outer cover
removed lower door switch
installed new switch
Wa La!
removed lower door switch
installed new switch
Wa La!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from SEVERN, MD
- Parts Used:
- 3501W1A019D
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
food does not get hot, carousel did not turn, all other indicators worked
Read the troubleshooting section on this site. Figured it was an interlock problem because the food was not getting hot (magentron not turning on) and the carousel was not turning. Did not think both the carousel motor and magnetron failed at same time, thus indicated an interlock problem. The interlock switches are actuated by the door latch. Replaced the assembly locker piece with all three switches (only a $20 dollar part) and microwave was fully operational again. Wife and kids think I am a hero.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Brenda from TALLAHASSEE, FL
- Parts Used:
- MJS47373304
- Difficulty Level:
- Difficult
- Total Repair Time:
- Less than 15 mins
Broken Glass Tray
It didn't work. It was too large. I need a glass tray NO LARGER than 13 1/2''. I received a 14" that was suppose to be comparable to the 13 1/2" glass tray that broke. The 14" is too large and wobbles. IF you have one that will fix my LG over the stove microwave Model # LMH 2016ST I would love to give it a try.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Suresh from RESTON, VA
- Parts Used:
- MEB41908102
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Nutdriver, Pliers, Screw drivers
Hard to take out old screws.
Self
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Timothy from DELAND, FL
- Parts Used:
- 4026W2A019A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Microwave door would not shut completely and would not activate switches
After checking all three switches for continuity I determined that the plastic door lever had warped or gone out of wack. After shutting off power at the breaker box I removed the door, the inside trim piece around the inside of the glass. Removed the black two prong door lever, reattached the new door lever and then reinstalled the trim piece and all screws. Works fine now. Easy fix just make sure your switches are all ok then replace the door lever.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Cheryl from MATTESON, IL
- Parts Used:
- MCK63604901
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
I had no problem it was quick simple and very very easy
Just snapped out the old one and snapped in the new one
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Alan from Moriches, NY
- Parts Used:
- MCK63604901, MCK62987001
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
Both covers were destroyed when the oven was on without any food inside.
Both new parts were installed simply by snapping them into the holes used by the old covers. What I did need was the single round headed push pin used to hold each cover in place after they were snapped into their respective mounting holes but, none were supplied with the new covers. Luckily, I was able to secure the old pins from the damaged parts that I had held onto and used them to secure the new covers. New pins should have been supplied with the new covers.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dave from FOREST, VA
- Parts Used:
- 4026W2A019A
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
Door locker snapped off
Unplugged the microwave. I opened the door. I used a butter knife to pop the bezel off the inside of the door. I pushed the locker up and to the left and used the butter knife to pry it loose. Disconnected the locker from the spring, and reversed for the installation.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Alice from Trenton, NJ
- Parts Used:
- MCK63604901
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
the stirrer fan cover meltted after I forgot to put the food in microwave and turned the oven on
I received the part and my son put it in where it belonged and no problems
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Susan from HENDERSON, NV
- Parts Used:
- 6549W1S013H
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
microwave dish would not move back and forth
unscrewed the bottom of the microwave and unplugged old part then took the screw out and put new one in. Super easy!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Rene from MORENO VALLEY, CA
- Parts Used:
- 4900W1A001B
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
Wanted to see the instructions before I install it.
Wanted to see the instructions before I install it.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Toni bc from PORT ORANGE, FL
- Parts Used:
- 4026W2A019A
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Latch broken... Spring off
You Tube
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- EDWARD from NORTH EASTON, MA
- Parts Used:
- 5889W2A012Q
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
the turntable ring broke
purchased a new one...thank you
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- George from MILPITAS, CA
- Parts Used:
- AGM73170602
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Glass on the microwave door had cracked and needed replacement.
I looked for the part on partselect website. The picture of the door assembly showed that i could not order the glass alone. As per the picture the glass was part of tge outer panel. I ordered the part and requested expedited shipment. But when I received the part, it did not have the glass in it. It was just the plastic frame. I felt cheated. When I called partselect, the said they could do nothing about it and asked me look for the part else where. I just lost $30. My recommendation is to never order parts from partselect.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- RICHARD from CARY, NC
- Parts Used:
- 6549W1S013H
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
microwave turn table not working
Removed the phillips screws from the base.
Using a # 10 secure driver, remove the motor. (I recommend obtaining a secure star driver set to be sure you have the right size)
Replace the spacer, which is a separate part from the motor.
Reinstall the spacer and motor.
Reinstall the bottom panel.
Enjoy!
Using a # 10 secure driver, remove the motor. (I recommend obtaining a secure star driver set to be sure you have the right size)
Replace the spacer, which is a separate part from the motor.
Reinstall the spacer and motor.
Reinstall the bottom panel.
Enjoy!
Was this instruction helpful to you?
Thank you for voting!