LMH2016SW (CWHELGA) LG Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Krzysztof from NEW BRITAIN, CT
- Parts Used:
- 5230W1A012E
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
Leek
Change gasket
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from PURCELLVILLE, VA
- Parts Used:
- 4370W1A006B
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
The new part was too thick for the worn out plastic ring which is obsolete.
Needed to raise the part to match the ring. I used peanut butter to hold plastic shim while replacing to hold it in place. Built in Oct. 2009.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- william from LA VERNE, CA
- Parts Used:
- 6324W1A001L
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Socket set, Wrench (Adjustable)
Unit would not heat
Used a Motor cycle Jack to remove both unites combined. Removed side panels exposing internal working parts. Removed nonworking Magnetron and replaced it with new Magnetron. The process was completed in about 1 hour.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Walter J Baxter from Billings, MT
- Parts Used:
- MEB41908101
- Difficulty Level:
- Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Screw drivers
First problem was removing the vent cover. There were four screws that were not obvious that held the cover on. Reinstalling the cover also proved to be difficult due to alignment problems. Once that was done, the second problem was removing the door. There is a small, almost invisible, latch that h
At home on the kitchen counter.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bob from OLD TOWN, FL
- Parts Used:
- 3861W2A006A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- More than 2 hours
quit working
the repair kit was useless the toggles were to big to go through the top the threads on the bolts interrupted the toggle i had to drill the holes thole to except the toggles I got bolts at the hardware store what a mess
Bob
Bob
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- thomas from NEWARK, DE
- Parts Used:
- 6912W1Z004B
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
need to replace the Nite light bulb
unplug microwave Remove light bulb hatch unscrew light bulb replaced bulb place bulb hatch back on to microwave plug microwave back in
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Paul from WOODBURY, MN
- Parts Used:
- MJS47373302
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Broken 14” glass tray
Simply set new tray on microwave rollers and insured glass groves fit on roller .
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Irving from BEDFORD, NH
- Parts Used:
- MJS47373302
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
broken glass
Just replaced the inner turn table glass tray
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Harvey from COLUMBUS, NJ
- Parts Used:
- MJS47373302
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Replace broken tray
I opened the door and slid the tray into place.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Stacie from Granbury, TX
- Parts Used:
- 6324W1A001L
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Microwave would not heat. Convection still worked.
I verified I had 120 volts going into transformer when the microwave was supposed to be running. The capacitor and HV diode both tested good. Be sure to discharge the capacitor before working in this area. This isolated trouble to either the transformer or magnetron. The windings of the transformer measured good. So ordered a magnetron. It was very easy to swap. There were 4 screws and one connector. This fixed our microwave.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kevin from Colonia, NJ
- Parts Used:
- 6600W1K001D
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
suddenly stopped working while in use
i unplugged the unit,unscrewed the outer shell so that all the wiring and internal components were visible.starting at the first of three micro switches i removed the slip on terminals installed the alligator clips too the wires so the switch would now be bypassed.i made sure the wires and clips were not touching anything plugged unit in and it worked.i then installed the new switch and closed up the outer shell
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Claude from PARK CITY, UT
- Parts Used:
- 5230W1A012E
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Air Filter Replacement
Originally called it "grease filter" until I found very small print "air filter" on damaged original. Part #PS3527528
Slipped into place with ease -- right bottom of microwave
Slipped into place with ease -- right bottom of microwave
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- RICHARD from CARY, NC
- Parts Used:
- 6549W1S013H
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
microwave turn table not working
Removed the phillips screws from the base.
Using a # 10 secure driver, remove the motor. (I recommend obtaining a secure star driver set to be sure you have the right size)
Replace the spacer, which is a separate part from the motor.
Reinstall the spacer and motor.
Reinstall the bottom panel.
Enjoy!
Using a # 10 secure driver, remove the motor. (I recommend obtaining a secure star driver set to be sure you have the right size)
Replace the spacer, which is a separate part from the motor.
Reinstall the spacer and motor.
Reinstall the bottom panel.
Enjoy!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from BIDDEFORD, ME
- Parts Used:
- MEB41908101
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Broken handle
Pulled off band unscrewed old handle and screwed on new one replace band
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gregg J. from WEST CHESTER, PA
- Parts Used:
- 4026W2A019A
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Door Latch spring keeper broke
Removed door from microwave and then popped the inside widow trim ring off. Removed 4 screws from the window bracket, replaced the latch with a new part and then assembled.
Was this instruction helpful to you?
Thank you for voting!