LMV1813ST (CS1ELGA) LG Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Marianne from CHURCH HILL, MD
- Parts Used:
- 6912W1Z004B
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
light bulb replacement
very simple
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Craig from Burke, VA
- Parts Used:
- 6912W1Z004B
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Light bulb burned out
I unscrewed the light cover, removed the burned out light bulb and replaced it with one I ordered on Partselect.com. It was very easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gustavo from Waukegan, IL
- Parts Used:
- AEB73006904, ADC73028303
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
The front glass of the microwave broke, the upper grill broke
To install the door, you need to pull the top grill(molding), remove the inner molding frame from the door. Hold the dor and pull it up to unlock and slide out. To instal new door, simply remove the inside plastic molding and place the for in. Replace the milding to lock it. Instal the upper grill ( molding). The control pannel might give an error at first. Dimply adjust the foor by closing and open several times.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Micheal from Mechanicsburg, PA
- Parts Used:
- ACM72981009
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Touch pad on controller unit stopped working
Unplug unit, open door, remove two screws top trim, then one screw at top of controller unit. Rotate right side of unit (facing it) out 1/2 inch first. Push unit up slightly to free the left side plastic clips then pull unit out. Remove 5 electrical connections. Installation is the opposite.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Richard from Bloomington, MN
- Parts Used:
- ADC73028303
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
plastic bosses on front panel broke so screws would not hold
Used screw gun with long bit to disassemble door and then to reassemble.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mark from Redding, CA
- Parts Used:
- AEB73006904
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
broken grill assembly
Grill would not go into place without removing the control panel. Had to remove one screw at top of panel and then install grill and control panel at the same time. Once all are in place you are unable to replace the screw holding the control panel. The grill seems to hold he panel in place securely. Should have been easier but the grill tabs just would not go into place with control panel attached.
Was this instruction helpful to you?
Thank you for voting!