RVM1325WW004 Hotpoint Microwave - Instructions

Since the job required replacing both the bulbs and sockets the unit was dropped from the wall. Used a towel and plywood to protect the range under the unit. Then these steps: Unplugged the power cable and placed a support board under the unit while removing three bolts from overhead cabinet. Next, removed support board and with a helper rotated the unit down and lifted it out of the rear wall mounting panel. Then turned the unit upside down, removed the bottom plate and unplugged the feed wires and two wires to each of the sockets. Next the single screws holding the sockets were removed and the sockets extracted from the mounting shells and new units were installed. When remounting the unit it was necessary to start all three bolts from the upper cabinet just a few turns and then tighten the center bolt completely first.

All one has to do is use a screw driver to remove the screws, one per lens.
Then lower the lens bracket, bend the 4 tabs holding the
lens, remove and replace the lens and screw the brackets back in place.

Less than 10 minuits.

changed the bulb

I asked a handyman at the local fitness center about repairing it and he refered me to your website where I found an exploaded drawing showing the parts I needed and how to get to them. It was great and very easy.

Replaced the fuse. Result; did not fix the problem.

Unscrewed the lens, it hinged down, then I could remove the frame. Pulled old bulb out and replaced with new one. Replaced broken glass in frame. Reset hinge into the holes and swung it up into place. Screwed it in.

Very easy!

Just unscrewed the screw holding the lens, unscrewed the bulb and put the new bulb in. Simple

so easy, but how do i turn light off?

Part recieved next day. thanks so much

removed the lens cover with one screw and replaced bulb

There is no repair story to share, I simply replaced the tray. However, I was very impressed with the speed that the tray arrived. I placed the order in the afternoon and the next day it was at my door waiting. This was the fastest delivery that I have ever experienced - at no extra charge. Also, the price of the tray was about $30 cheaper than ordering from Sears.

I ordered a glass microwave cooking tray to replace one that shattered over the Christmas holidays. Tray was sent out in a few days, but received in broken condition. After notifying PartSelect, another tray was sent out immediately. Everything went well and the folks at PartSelect were supportive and resonsive.

Installing a glass tray is no big deal, but finding it and at a price that didn't make me choke was a trick! I did that with you guys and I really appreciate it! Customer Service was amazing as well. The first shipment took quite a hit and the tray was broken. My response from you about my problem was quick.....and on a Saturday. I had another tray by Tuesday! Thanks!

Thank you. Your service was fast and very easy. The cooking tray arrived in two days. Spouse now knows that if he chips the tray again ($70.), Thank you for your prompt and accurate service.

used the part I requested and a few extra bolts...job well done!

First unplugged the microwave, took top grill off, took control panel off, took wires off and used color coded tape to make sure they went back in right places, took fuse out and replaced it and put every thing back and it all worked fine and to top it off my wife did it all. So it was pretty easy.