RVM225WL002 General Electric Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Richard from Skillman, NJ
- Parts Used:
- WB15X322
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Microwave handle broke off
I removed broken handle, then simply attached the new handle with two screws.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Aubrey from Silver Spring, MD
- Parts Used:
- WB15X322
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Handle was broken
Removed old handle. Cleaned area on microwave door. Screwed hanle on.
Was this instruction helpful to you?
Thank you for voting!
Microwave will not start
Removed three screws from the top front cover and slide it out and following I removed the touch panel and the housing that holds the switches and replaced the bad one.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Rick from Muncie, IN
- Parts Used:
- WB24X829
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
microwave Quit working but lights worked
llation
Was this instruction helpful to you?
Thank you for voting!
Still runs even the door was open
Pulled it from the wall remove the front vent covers removed the control panel remove the door switches by a special screw driver bit which looks a star remove the electrical terminals pressed the plastic clip pulled the switch replaced it with new one then followed initial steps backward
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Eugene from Elkridge, MD
- Parts Used:
- WB15X322, WB06X10140
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Screw drivers
Microwave Door Handle broke at bottom
When I tried to remove the handle, I discovered someone (teenage step daughters) attempted to glue the broken handle to hide the fact that it was broken. It did not work. The handle broke again, leaving part of the handle assemply suck in the door. I had to use a cordless drill to drill out the glued in portion of the handle. Fortunately, when the drill bit dug it, it broke the glue seal and the broken insert came out. After that, it was a breeze to install the replacement door handle.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- steven from wilsom, NC
- Parts Used:
- WB15X322
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
handle didn't come w/new screws
I had to shim the outside to get the door tight,the original screws are longer than what the current handle requires.For the price ,new screws should be a part of the package.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Janet from TREASURE IS, FL
- Parts Used:
- WB36X10003
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Under the microwave there are two light bulbs that light up the top of the oven/range.
Last week I removed the glass cover that was held in by one screw and removed the burnt out light bulb. I ordered the bulb and left the glass cover off until the bulb arrived. I had to wait until this evening to put the glass cover back on and fasten the screw because I have a window right next to the oven and the sun streaming in made it too difficult for me to see how to put the glass back in and replace the screw.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from Berwick, IA
- Parts Used:
- WB15X322
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Broken Door Handle
Removed 2 screws. Placed new handle in position. Installed 2 self tapping screws. 2 Minutes to find phillips screwdriver, 1 minute to install screws.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Theodore from New Bern, NC
- Parts Used:
- WB15X322
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Microwave door handle broken
Used Phillips #2 screwdriver to remove old handle.
Used the two original screws to attach the replacement handle. Repair completed in less than 5 minutes!
Your web site was easy to navigate, delivery was fast, and the price was fair. Thank you, thank you, thank you!
Used the two original screws to attach the replacement handle. Repair completed in less than 5 minutes!
Your web site was easy to navigate, delivery was fast, and the price was fair. Thank you, thank you, thank you!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Richard from Concord, MA
- Parts Used:
- WB15X322
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Microwave oven handle broke loose at bottom of door.
Philips Head #2. Two srcews out....two screws in. A perfect fit!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Elizabeth from Santa Rosa, CA
- Parts Used:
- WB15X322
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Door handle broke
I removed the one screw, the other end was broke. Replaced the handle. At first it didn't screw in tight, so I turned it around and put in both screws and bingo, good as new. Thanks for your quick response. Was simple.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jorge from Pleasanton, CA
- Parts Used:
- WB15X322
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
the handle was broken
just screwed the new part
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Darenda from Houston, TX
- Parts Used:
- WB15X322
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
The handle broke at the bottom.
I removed the existing screws and removed broken handle. Wa able to still use existing screws and install new handle. Very easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Timothy from MAYSVILLE, GA
- Parts Used:
- WB24X830
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Microwave would run but not heat
Removed the control panel, one screw at the top. Removed 2 screws on the door switch holder and removed the door switch. VERY EASY.
Was this instruction helpful to you?
Thank you for voting!