JVM1330BWC02 General Electric Microwave - Instructions

Removed one screw, installed new lense in lense frame, rescrewed. Done.

Simple. The parts came instantly. The glass was too big so I had it cut to size. I unscrewed the fixture with a screw driver replaced the bulb and slipped the glass cover into the frame and screwed the whole assembly in.

I looked at what others ahd said about the repair and just followed their instructions. Just took off the top screw of the handle, used a butter knife to pry off the plastic cover around the inside door and took off the bottom screw of the handle. Put the new handle on and put the screws back and pushed the door frame back in. Very easy to do and took very little time.

Removed difuser (one screw), removed old bulb, screwed in new bulb, replaced difuser.

pluged wires back on ,placed lamp holder and bulb back and replaced screws

Open the microwave door. Remove the exposed screw in the top left hand corner. Using a knife, pop off the plastic moulding that surrounds the glass out to expose the screw in the bottom left hand corner of the door. Remove that screw. (note they are two different types and lengths). Attache the handle and screw in the top screw, then the bottom screw. Re-attache the moulding around the glass. Close the door and reopen with new handle.

took out several screws dropped down the panel under the microwave and unscrewed the bulb and put the new one in. It was a simple job.

Once on your web site it gave me a skematic of my microwave which showed me how the parts connected. I saw how easy it was and I saw what type of bulb it was I ordered the parts and it took less than 15 minutes to repair. Thank you so much for your site, It is now on my favorites list. Doug

2 screws off and 2 to put it back on. Not hard at all. Quick and easy.

Used a phillips head screw driver and loosened the lens frame under the microwave. Removed the broken lens and replaced it with the lens ordered. Put the lens frame back in place and secured it with the phillips head screw.

remove cover, unplug secondary door switch (top switch)
remove switch from holder, install new switch, plug in wires, replace cover, very easy. door switches are a common problem
with microwave ovens.

Removed Cover Plate,
Removed back cover
Bulb disintegrated removed base with pliers
Screwed in new lamp
Replaced cover
Done

the top screw is plainly visible, the bottom screw is not and may give pause. If you remove the plastic ring, on the interior face of the door, it will give access to the bottom screw for the handle. While you have the handle off, remove the backing plate for the handle, on the front of the door by pulling outward, gently until it pops off. Then you can slide the front glass panel out and clean it. {CAUTION: do not spray any cleaner on the exposed glass with the mesh on it, it will be impossible to remove any liquid and will cause fogging when you replace the outer glass panel}. Replace clean glass panel, and handle backing plate, make sure it snaps in fully so the screw holes line up properly. Screw on new handle, replace plastic ring and you are back in business.

My son repaired it. The difficulty was because there was no schematic included and we couldn't figure out how to access the screw at the bottom of the handle. My son downloaded a schematic from the internet and finally figured out how to do it from that, but it would have been a lot quicker and easier if one had been included with the part. I was very satisfied, however, with the speed of the delivery.

Used thin spatula to remove plastic frame around inside of door to expose bottom screw. Removed top and bottom screw and pulled off broken handle. After cleaning up the outside of the door, installed new handle and tightened screws. Popped plastic frame back into place: done!