JVM1350BWC01 General Electric Microwave - Instructions

The handle worked great, the only thing was that it didn't come with the screw for the handle and I thought it would. The part description was very vague. So we have the bottom part of the handle super-glued and found a scrap screw that we could use for the top. At least it was better than no handle.

Thanks much,
Cheri Morena

Screwed in new bulb.

pluged wires back on ,placed lamp holder and bulb back and replaced screws

Removed difuser (one screw), removed old bulb, screwed in new bulb, replaced difuser.

I looked at what others ahd said about the repair and just followed their instructions. Just took off the top screw of the handle, used a butter knife to pry off the plastic cover around the inside door and took off the bottom screw of the handle. Put the new handle on and put the screws back and pushed the door frame back in. Very easy to do and took very little time.

Open the microwave door. Remove the exposed screw in the top left hand corner. Using a knife, pop off the plastic moulding that surrounds the glass out to expose the screw in the bottom left hand corner of the door. Remove that screw. (note they are two different types and lengths). Attache the handle and screw in the top screw, then the bottom screw. Re-attache the moulding around the glass. Close the door and reopen with new handle.

Removed one screw, installed new lense in lense frame, rescrewed. Done.

Tyring to get bulb out i ruined the light socket. Unscrewed the bottom cover of microware. Took out screw holding light socket, removed wires to socket with pliers, intsalled new socket. It was a piece of cake and the part was a perfect match.

Replaced - unscrewed top screw, removed door gasket with spatula, reveiling bottom screw to unscrew. Replaced handle,screw back on and replaced door gasket. Follow instruction on web site. Help greatly

took out several screws dropped down the panel under the microwave and unscrewed the bulb and put the new one in. It was a simple job.

Once on your web site it gave me a skematic of my microwave which showed me how the parts connected. I saw how easy it was and I saw what type of bulb it was I ordered the parts and it took less than 15 minutes to repair. Thank you so much for your site, It is now on my favorites list. Doug

Used a phillips head screw driver and loosened the lens frame under the microwave. Removed the broken lens and replaced it with the lens ordered. Put the lens frame back in place and secured it with the phillips head screw.

2 screws off and 2 to put it back on. Not hard at all. Quick and easy.

the top screw is plainly visible, the bottom screw is not and may give pause. If you remove the plastic ring, on the interior face of the door, it will give access to the bottom screw for the handle. While you have the handle off, remove the backing plate for the handle, on the front of the door by pulling outward, gently until it pops off. Then you can slide the front glass panel out and clean it. {CAUTION: do not spray any cleaner on the exposed glass with the mesh on it, it will be impossible to remove any liquid and will cause fogging when you replace the outer glass panel}. Replace clean glass panel, and handle backing plate, make sure it snaps in fully so the screw holes line up properly. Screw on new handle, replace plastic ring and you are back in business.

Removed Cover Plate,
Removed back cover
Bulb disintegrated removed base with pliers
Screwed in new lamp
Replaced cover
Done