JEB1860SMSS General Electric Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Henry Lindsey from Slidell, LA
- Parts Used:
- WB26X10143
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Turn plate started making clicking noises and eventually stopped turning
It was extremely easy. I put the microwave on my table upside down and could see the motor thru the holes in the bottom cover. It appeared as though the outside skin had to be removed to access the motor but after looking at it there is an access panel I did have to cut it loose. Not bolted on. There was a message stamped into the bottom case next to the panel that said to debur after panel is removed. So I cut it loose on 3 sides was able get to the one screw swap the motor and reinstall it in about 5 minutes. It works like new What an easy and quick repair. Thanks
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kristy from Blue Bell, PA
- Parts Used:
- WB49X10135
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The glass turntable was cracked in half
I removed the new tray from the box and slid it into the microwave. That's it.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Tammy from Buckeye, AZ
- Parts Used:
- WB49X10135
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Renter broke the tray
Very easy you just have to make sure that the tray is in the groves for the wheels :)This is the best place to shop as I have used them on all kinds of appliances and they have never let me down when it comes to price and delivery time!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Barbara from Meredith, NH
- Parts Used:
- WB49X10135, WB06X10584
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
glass tray cracked and broke and the rotating ring did not rotate
Easy-easy-easy...just took out the old broken tray and installed the new one. We did the same with the ring. The service from this company was excellent!! Ordered on a Saturday and received it on Tuesday....
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Edward from Cypress, TX
- Parts Used:
- WB06X10584
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
the rotating ring broke.
remove the glass, remove the rotating ring, install the new ring, replace the glass and my wife fixed it in 30 seconds.thanks for the providing the part.Ed
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from Roanoke, VA
- Parts Used:
- WB26X32629
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Microwave would not heat
I went on line, put in microwave repair and watched a video on repair. I then took the oven down from over the range and took it apart. I could see were the magnetron had burned out. There was a hole with obvious burn marks. I went on line looking for the needed part. I clicked on PartSelect and order the magnetron. I received the part within three days, regular shipping. As I had not put the oven back together it took only a few moments to save 150 to 200+ dollars. I put it back together and happy, happy me, it worked.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- TROY from DIXON, CA
- Parts Used:
- WB06X10584
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Original "Rotating Ring Guide" was broken where it goes through the bottom of the microwave.
I installed the new "Rotating Ring Guide" by setting it on the floor of the microwave with the gear socket going through the bottom of the microwave to engage the gear that turns the rotating ring guide. I then set the glass cooking tray upon it and the job was done. About 30 seconds start to finish.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Norman from Raleigh, NC
- Parts Used:
- WB06X10567, WB06X10210
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
Cover stirrer melted because microwave was left on with nothing in it.
I only had to snap the parts into place
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from Fall Branch, TN
- Parts Used:
- WB27X10928
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
microwave just stopped working
First unplugged the microwave, took top grill off, took control panel off, took wires off and used color coded tape to make sure they went back in right places, took fuse out and replaced it and put every thing back and it all worked fine and to top it off my wife did it all. So it was pretty easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sam from Chandler, AZ
- Parts Used:
- WB24X10047
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
When trying to run, intermittently, the light would come on but the tray wouldn't rotate or cook. When the door was open, the tray would intermittently rotate.
I pulled out the unit and found 2 interlock switches that are depressed when the door closes. After cycling the door open/closed I found that one of the switches occasionally would stay depressed. The repair was easy (after I took off the panels so I could get to the switch) I simply removed 2 screws that attached the interlock switch assemblies to the main unit. Then I popped out the defective switch and popped in the new one. This did indeed fix my problem.
Was this instruction helpful to you?
Thank you for voting!