GLMV169DBB Frigidaire Microwave - Instructions

Took longer than it should due to no instructions being in box. The removal of the old door took approx 30 secs and was self explanatory. Once I realized I had to remove the plastic inner panel on the new door to re-install it, it also took only minutes. Could have been an easy fix with instructions.

My husband did it by just taking off the panel on the top of the microwave and replace old with new. We cleaned up some of the accumulated grease as well on the microwave. He had a little problem with the screws. We have done this before so no big problem. Thanks

After trying to bend parts that do not bend I realized you need to remove the plastic gasket around perimeter of microwave door but leave it loosely hanging on (pry off with screwdriver) With the gasket removed you can fit the door on and the snap the gasket back in place before closing and testing. The door was a perfect fit, it works great. The door will not go on until you remove or bend back that gasket. It's not obvious how or where to remove but just put a screwdriver in there and you'll feel it pop out and it snaps right back in after assembly..

Easy as 1-2-3! Removed door from unit (top right hinge has an easy small lock that simply "snaps out" with a standard screwdriver. Placed door face down on table. Removed outer (perimeter) frame with standard screw driver, by plying up. Removed the two screws (to the handle) from the backside of door with a phillips screwdriver. Replaced with the new door handle and repeated the above steps in reverse. Done.

Slipped the screw driver flat tip along the plastic strip near the latch inside of door to pry off the plastic cover to expose the screws holding on the door. Removed 2 screws and replaced handle less than 15 minutes.