AMV5206BAS Amana Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Raymond from TROY, OH
- Parts Used:
- 3405-001034
- Difficulty Level:
- Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Screw drivers
The microwave would not turn on or would run with the door open
Other tools that are usefull long needle nose pliers, long thin blade screw driver and small magnetic flashlight. Place the microwave on a work bench and remove the case it cover 3 sides. Place the microwave on a chair so it can stand with the controls up. You are replacing the lower door microswitch. The switch is located behind the control panel in the lower part of the area. The switch is several inches inside this area and your hands will not fit. Take care when moving wires and a couple of sensors. Use the thin blade screwdriver to release a tab holding the switch in place. Do not break this tab. Take the needle nose pliers and remove the switch. Put the wires on the new switch, open the door a short distance so a door lever moves enough to put the microswitch back into the bracket.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- AMANDA from ANKENY, IA
- Parts Used:
- DE92-90505G
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
I picked up a used microwave that came with the needed mounting plate but no screws
Based on my research, this over the range miscrowave should have come with 2 templates: 1 for the wall and 1 for the underside of the wall cabinet. The challenge was to measure every very aspect of that microwave in order to obtain placement specs for the mounting screws. Tip: I made the holes through the top cabinet bottom a little larger than needed and used big washers with then for stability to gain the most "play" in the self aligning screws. Worked out well. Took 2 tries to get the wall plate perfect so have precision in mounting that piece.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Linus from Grey Eagle, MN
- Parts Used:
- DE67-00213A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Turn table would not rotate
Removed old coupler put in new
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from Dix Hills, NY
- Parts Used:
- DE67-00213A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
disk did not rotate!
I looked up maytag Model on internet and located part. Ordered part on internet and replaced part on maytag microwave.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- SALLY from LAGUNA NIGUEL, CA
- Parts Used:
- DE67-00213A
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
Turntable stopped turning
I tried before to replace the coupler but ordered the wrong part from a different company. Your website allowed me to narrow down the search and choose the correct coupler from about 8 different choices.It took me literally 2 minutes to fix my turn table. I am a single mom with a disabled child, so the option of paying a repairman to fix my microwave was not an option. Thanks!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sandra from Hudson, FL
- Parts Used:
- DE67-00213A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Turntable would not turn. The coupler was broken
All I did was removed the glass revolving tray and insert the coupler. Couldn't have been any simpler and the turntable was working again. Part was received the same week it was ordered. Very quick and didn't use any gas to go out somewhere and look for the part. Very pleased!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dawn from Irene, SD
- Parts Used:
- DE67-00213A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
piece holding turntable plate broke off
strategically placed coupler in the hole and wallah! placed the plate back on it and watched her go around! Feel like a genius! lol
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Richard from Magnolia, AR
- Parts Used:
- WPDE31-10172A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Turntable motor would not turn food tray
Replaced with new motor from Parts Select. Part was a correct replacement for the old one. perfect fit. Works like it did when it was new. I will recommend Parts Select to anyone. Thank you very much. I would definitely use your company again in the future. I saved $30 by not using parts from GE.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Elaine from Allison Park, PA
- Parts Used:
- WPDE97-00672A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Bought microwave and it had no hanging screws with it.
Ordered part and screwed in. Part could not be found in hardware store even though it was just a long set of screws. Agent quickly identified part with model number of microwave and it was at my home the next morning for installation. Great service!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Catherine D from Southampton, PA
- Parts Used:
- DE67-00213A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
The original coupling holding turntable broke
Took the broken coupling out and put the new coupling in
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- JOE from Grand Prairie, TX
- Parts Used:
- DE67-00213A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Turntable Not Turning
After contacting parts select they assisted me in ordering the correct replacement part. The folks I talked to on the phone WERE EXCELLENT in working with me to fix the issue. I has ordered a coupler that dammaged after a week of use and they replaced immediately telling me I had a year warranty! Great Company and Thank you it is working perfectly.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- JIM ODANIELL from WILMINGTON, NC
- Parts Used:
- DE67-00213A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Rotating Tray fails to turn
Very easy. Opened the Microwave door, removed the dish and replaced the coupler.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Tasha from York, PA
- Parts Used:
- 4713-001165
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Light under the microwave went out
To replace the light bulb was fast and easy. All I had to do was unscrew one screw and place the bulb in! Quick and easy, and simple!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Denise from Clovis, CA
- Parts Used:
- DE67-00213A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
tray would not rotate
Snapped the coupler in place. Took one minute.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Julie from Seattle, WA
- Parts Used:
- DE67-00213A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The turntable on the Microwave stopped turning
Asked at Best Buy what our options were after I described the problem. They said to buy a new Microwave. I thought No way it is only a few years old. Whent home did som research and found your site and for under $5.00 My microwave turn table turns again!
Was this instruction helpful to you?
Thank you for voting!