CED7011LW1 Whirlpool Dryer - Instructions

Followed the included instructions in the Maintenance kit. Very easy to understand & follow. Only advice is to have an extra set of hands to assist in re-installing drum w/ the new belt. Entire disassembly & reassembly could be done w/ basic hand tools but went alot quicker using a cordless drill w/ a set of nut/screw driver bits.

Opened the cabinet and removed the drum. Cleaned out the dryer fuzz. found that the roller stabilizer wasn't in place; apparently due to a previous repair. Replace both rollers and the roller stabilizer and prepared to replace the drum. But because I live alone, I didn't have anyone to hold the drum while I connected the belt to the motor. But, I did have three unused balloons which I partially inflated and set the drum on them in the bottom of the cabinet while I hooked up the belt to the motor. Put everything back together and it is now drying my clothes again. :)

flipped up the top pulled the front off easy access to drum removed the drum replaced rollers per instructions that came with package. very eas job. works great.

Watched the video, followed the printed instructions for reminder when necessary. Needed a second person briefly to hold the dryer tub when installing the new belt, and also when removing/replacing the front panel. Beyond that, it was straight forward and relataively easy to do. Solved the noise problems and it dries more evenly now as well. The one thing the instructions don't say is to check the rear canvas seal when the tub is re-inserted into place to assure it doesn't fold back on itself.

My son did the repairs it took less than 30 minutes it's an old dryer so glad to be able to get the parts. I do not like the new dryers because of all the pushbuttons thanks so much for the ports

New handle just snapped in - really easy. Have to compliment Part Select - I ordered handle one day and it was delivered the next day. Impressive!

I snapped the new handle into place, it took 2 seconds. The new handle was made thicker and stronger than original. Its unlikely I will be doing this repair again.

When I ordered the part over the phone was told it just snaps in. Not sure what it meant. Parts delivery was prompt. Looked at the part and it’s pisition on the dryer.And it really was very simple.

ordered a replacement handle - installed it myswelf

We didn't even look at the instructions. Just rotated the handle until it snapped back into place.

Just popped it into place. Was very easy. Took less than 5 minutes.

Followed the instructions found online. Only thing I would add is that the clips are easier to work with if you warm them up a little before you try to install them.

I thought I had checked the arm piece of the rack real good for a product number on my original part but I missed the number till the 2nd box came in, and a looked real careful and realized it was the same as the order I thought was bad.
Put the spring arm in first and the rack will fit in the front groove.
It would have been good if there had been a picture of the dryer arm attached to the dryer.
So I have 2 good racks and will return one if you tell me where to send it.
Keith Walden..

Pretty much followed your great video: . Watching it gave me the confidence that I could accomplish the job myself.

I opened the package with my new handle in it that I got from PartSelect, and snapped it right in place. No tools needed, took only seconds!