Models > 7761A-77 > Instructions

7761A-77 Norge Dryer - Instructions

Jump to:

All Instructions for the 7761A-77
121 - 135 of 154
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Todd from San Antonio, TX
Parts Used:
LA-1008
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers, Socket set
Squeaky wheel
Basically I started off using youtube to see how to install. Two things to be sure you do – one the plastic washer only goes on one side (read the instructions)of the shaft and two the support brackets are not threaded so you need to use the original self-tapping screws. The screws that come with it will not work. Best to use a socket set to install the screws.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Herbert from GOLD BEACH, OR
Parts Used:
12002126
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Pliers, Screw drivers
when we were cleaning the fan we discovered the teflon coated guide had broken
the hardest part of fixing it was getting the belt off the roller guide. the actual part was easy to fix
Was this instruction helpful to you?
Thank you for voting!
Customer:
Roger from Merrillan, WI
Parts Used:
LA-1008
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers
left roller support shaft has flat on one side
1.used small flat head screw driver to pop top of dryer. 2.used phillips screw driver to remove front of dryer. 3.disengage dryer belt. 4.take hold of brum and turn and pull out. 5.{left side}take snap ring,washer,roller off then remove support shaft. 6.install new parts, support shaft,roller washer, snap ring. 7,right side has a plastic washer that goes on before roller rest will be as step 5 8.put dryer back together.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jim from North Smithfield, RI
Parts Used:
LA-1008
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
Dryer belt broke
took the dryer apart noticed it needed a belt and rear drum supports. Ordered the parts(they were very helpful on getting the right part . they came in very fast (less than 24 hours). replace the broken parts. The dryer is working great.
Was this instruction helpful to you?
Thank you for voting!
Customer:
KIenny from Bloomington, IN
Parts Used:
WP31001529
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
old door seal came off and tore up
order knew door seal fix was a snap just Snap in place
Was this instruction helpful to you?
Thank you for voting!
Customer:
David from Hampton, VA
Parts Used:
WP31001529
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
seal was loose and letting air escape
Pulled the old one off .Dry fitted the new one and pushed the retainers in place,took about 5 minutes.thank you.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Lisa from Mesa, AZ
Parts Used:
WP53-0918
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Lint Filter fell apart
The new filter did not fit properly. Used a buter knife to remove teh lint build up and WOO HOOO! the new filter fits perfectly :-)
Was this instruction helpful to you?
Thank you for voting!
Customer:
Doug from Kearney, NE
Parts Used:
LA-1003
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Latch was broken so door wouldn't close
This was real easy just slid the latch in front panel and attached to latch assembly to the door. The repair was about 45 seconds.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Patricia from dumfries, VA
Parts Used:
WP31001529
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Door seal beginning to rot
PS2031037 Door Seal We were amazed at how quickly to find the site, order the part, RECEIVE the part. In just a matter of a few days, dryer was once again functioning properly. Seldom do Retailers get it, YOU GUYS GOT IT! Thanks very much
Was this instruction helpful to you?
Thank you for voting!
Customer:
Lonnie from Soda Springs, ID
Parts Used:
53-1518
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver
terminel block melted
replaced the terminal block
Was this instruction helpful to you?
Thank you for voting!
Customer:
Leora from Portland, OR
Parts Used:
WP53-0918
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
dryer filter died
took old filter out and installed new one. It was a little tight but it's working great.
Was this instruction helpful to you?
Thank you for voting!
Customer:
judy from sun city, AZ
Parts Used:
WP53-0918
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
dryer filter was torn
Replaced it.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Kim from North Windham, CT
Parts Used:
WP31001529
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
door seal was dry rotted
carefully pulled out old seal, then popped in new seal
Was this instruction helpful to you?
Thank you for voting!
Customer:
Pamela from Little River, KS
Parts Used:
WP53-0918
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
need new lint filter
I bought from you and received part in timely manner. I got it out of the box and replaced. It's better than the one I got new with dryer. Thanks, P.Blades.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Carol from Berkeley, IL
Parts Used:
WP53-0918, WP31001529
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Dryer time is very long. Lint not collecting.
I removed the old door seal and installed the new one algining the slots with the inserts and the seals. Old filter out, new filter in. Install was successful but dryer still not drying even though it's producing heat. I guess I will need a replacement.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the 7761A-77
121 - 135 of 154