PSXH43GV2WW General Electric Dryer - Instructions

I followed the instructions in a Youtube video that an individual made with his kids. The only hard part was removing the drum assembly, the rear drum bearing was very difficult to unseat. I had to reattach the front of the dryer to give the drum assembly more support to be able to lift the rear - but overall it was quite easy to figure out disassembly and reassembly of the dryer. There's really not that much to them.

Follow instructions all most to the letter. In video it was stated to get an assistant to hold static / housing retainer in place to start screws. I put it in place and, used Duck Tape to hold it there while i started screws. Thanks for the deal on parts and, video. I would also suggest advising to check the nylon strips on felt at the front top. Mine were worn. But there was enough at the back of nylon to remove and, glue remainder in place almost as good as new. Again! ''THANKS!''

Replaced rear bearing on back of dryer. Repair cost $20.00 an a little time. Much better then buying a new dryer. It was easy to repair the video instructions were great. I would do it again it needed.

followed vidio instruction which made it easy

purchased bearing kit

I ordered the rear drum assembly on Monday evening and the part came on Wed at 11 am. I started the repair at 1 and finished at 3. It would have been faster, but my computer kept freezing during the repair video. The video was so easy to follow. I could have used longer arms or a helper, but I managed to get the job done by myself. Needless to say, my husband was thrilled. Great service. Thanks

I used the video, and it helped me a lot! I got the drum out, installed the new bearing, greased the new shaft and the receptacle, then I reassembled. When I tested it, mine was still very noisy, so I removed the drum once more and cleaned/added some grease on the tensioner bearing. This was the cause of the noise in my case, but the bearing & housing were nearly shot, so something would have given out very soon. I would suggest to grease the tensioner the first time to save time and effort. (And save some of the grease for the tensioner pulley). SAFETY TIP: there was also a ton of lint that got trapped inside the unit!!! Clean your dryer once per year to prevent it becoming a fire trap!

Very simple just put the new ones on to replace the old knobs that broke. Thanks for the quickness of getting our parts to us. So nice to not have to use a tool to turn the dryer on. Very happy with the pricing and quickness it was delivered to us.

When the new knob came I just lined it up, the flat side of the stem with the flat side of the button and then just pushed it on.

I pulled off the broken knob and black fitter that was originally on the plastic piece. I didn't even need pliers. Then I replaced the new rotary knob under 5 seconds. Now the dryer works like new.

Not much needed to replace a broken knob. I was very impressed with the fast service and will recommend Partselect to my friends.

EZ order, EZ pay, EZ shipping, EZ install. Fantastic!

buy need knob

Easy peasy! It is as easy as lining up the knob with the D shaft on the dryer. There is a small piece/ring around the shaft that can still be stuck up inside so if you can't get the knob to sit flush with the dryer, peak inside and slide it off with a pair of pliers (the repair video shows this clearly if you need an example). I was done in 2 minutes, including the time it took to open the package!

Pulled the old knob off to get part number. Ordered replacement part. When it arrived, I pushed the new knob on the shaft. It ain't rocket science! Thanks for you quick, efficient service.