GTMP280GD6WW General Electric Dryer - Instructions

just put new one on. no tools needed fits in holes already there. handle just snaps on,

This one is so easy my grandson could do it. The removal was easy, it broke off. The installation was a "snap in place". Thinking I needed a few days of dryer use without the handle, I made a temporary repair. I fished some heavy packing string thru the slots in the door, made a loop, than a knot. This gave my wife something easy to grab to open. Did not even need to do the temporary repair, the part arrived in one day.

As soon as the new door handle arrived, I just snapped it into place. It took about two seconds>

I just snapped the door handle on the dryer in less than a minute. I am completely satified. Did I mention I received my part in one day. I ordered online before 3pm and received it the next day before 11am. Very impressed. Thanks PartSelect!!!

I broke the handle

I ordered the new part as listed and it came in two days, which was amazing to me since it was the week before Christmas. I snapped it in in less than a minute and all is well. Thank you for being so prompt on sending this out. Made the holidays a lot easier.

Clipped on.

No tools needed as old handle had come out on it's own when it broke. Simply removed duct tape that was used holding old one in place till new one arrived. Placed new one in position and snapped into place to hold. Less then a minute to install. Very pleased and surprised in how fast delivery of part from PartSelect was. Basically had it in 2 days. Will use them for other replacement parts as the need arises.

replace control knob

Snaped the new handle back on...no tools needed,
just fit the plastic groves of the handle into the holes on the dryer door. Very simple!

All the stores had either a smaller watt or a larger watt and the book suggested always using the correct watt. I was glad to find it on this sight and it was delivered very quickly.

I noticed that some clothes were coming out of the dryer looking like they had been chewed on. The next day something actually caught on something inside the dryer near the door. There was a broken piece of plastic. I wrote the dryer model number down and came to this website. I easily determined it was the drum bearing from the pictures provided by this website. The part came 5 days later. I think it would have been sooner, but I ordered on a Friday before a 3 day weekend (Memorial Weekend). I did not order the slides recommended to be ordered with it because my dryer was not making noise. When I replaced the drum bearing, one slide was worn completely through and the others were fine. The one worn through was right near where the plastic on the drum bearing was broken. I ordered a green slide to replace the one that was worn through.

Replacing drum bearing required the removal of 4 screws total. 2 inside dryer doorway, these two were facing towards the ceiling. After removing those two the dryer top popped off easily and did not require the removal of the control panel at the back of the dryer. The other two screws were inside and were small screws which held the front dryer panel onto the sides. After these were removed I pulled the front panel away enough to get to the drum bearing. Easy Peasy!

Removed door and two screws to replace the door handle. Reassemnled in reverse order. It was a snap.

Installed new part

Very satisfied. I simply took the plastic door handle out of the package and snapped it into the door. It popped right in and fit perfectly!