GLEQ642CAS1 Frigidaire Dryer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- James from Springfield, MO
- Parts Used:
- 131873500
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken Timer Knob
Slid new knob on shaft. Done.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- RAMIN from DOUGLASTON, NY
- Parts Used:
- 131873500
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
dryer knob was broken
Purchased new knob and put in place this company was great received with a day or two
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from El Dorado Hills, CA
- Parts Used:
- 131873500
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
broken timer knob
ordered part, 4 days delivery, snap on. DONE
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Nick from El Paso, TX
- Parts Used:
- 131873500
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Timer Knob broke to the point that it only turned around on the shaft but did not move the setting
Pulled off the old one and put on the new one. It was as simple as that!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Botter from Livingston, TX
- Parts Used:
- 134503600
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver
Drum was not turning
Removed access plate in rear, raised top panel, removed two screws holding front panel (with door) put new belt over drum. Threaded belt through path between motor drive and idler wheel. Put everything back together.
My order was shipped very promptly, and was received very quickly. It is wonderful to have this service available on the internet. I can remember how difficult it used to be chasing down parts before. This was impossible in smaller cities.
My order was shipped very promptly, and was received very quickly. It is wonderful to have this service available on the internet. I can remember how difficult it used to be chasing down parts before. This was impossible in smaller cities.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Roger from Bossier City, LA
- Parts Used:
- 134503600
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
Broken belt and idler pulley
Removed top and front of dryer and rear panel. Installed belt and new idler pulley. Reinstalled top and front panel and rear panel. Dryer worked great.
Was this instruction helpful to you?
Thank you for voting!
Squeaking noise as the drum turned
I love technology. First thing I did was google on "U-tube", "How to repair a squeaking dryer". Several videos out there so I just found the one I needed and watched. The repair itself went easy. A word of advice would be to be careful of sharp edges and to remember to unplug the machine prior to repair. While the drum is out, go ahead and get your shop vac and clean the inside of the unit out. Also, not only put grease on the new plastic holder, but put some on the shaft of the idler puller. I also used an awl to line up the holes on the front panel when re-installing the screws. One video I watched showed reaching in through the front to take the drum belt off the pulley, where another showed removing the inspection plate on the back. This made it much easier.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gloria from Murfreesboro, TN
- Parts Used:
- 131825900
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
The dryer tub started screeching and then dropped.
Removed the top of the dryer above the dryer door by pulling the pop out plastic holds. I then removed the dryer plug in at the top inside dryer that controls the start when dryer door is closed. I thenremoved the screws that are located at the back of the dryer tub where the bearing is located. I then replaced the support bearing. I just replaced every thing I took off in reverse.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- TERRY from Bowling Green, OH
- Parts Used:
- 131553900
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
Dryer wouldn't heat
Removed obvious screws to the vent etc. Then had a little trouble getting the cabinet open. My only problem was getting the front top panel off. A clip about 2" from either side at the top needs to be pushed in with a flat head screwdriver to release the top. Other than that the task was pretty straight forward. Two sets of wires to the heater itself. Used pliers to help pull them loose.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Joel Scott from Beaverton, OR
- Parts Used:
- 131873500
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Dryer control knob mount cracked
As simple as pulling off the old, broken knob and sliding on the new one. 20 seconds tops.
Ordering on Partselect.com was easy, and shipped fast. This was my second order with Partselect.com, and I will order from then again, when whatever else can go wrong, goes wrong!
Ordering on Partselect.com was easy, and shipped fast. This was my second order with Partselect.com, and I will order from then again, when whatever else can go wrong, goes wrong!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Roy from Anchorage, AK
- Parts Used:
- 131873500
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Wife went on vacation and I broke the timer knob on the dryer the first time I used it!
I opened the envelope that was waiting on the porch when I got home from work, opened it up, and pushed it on the shaft. It fit like a glove and looks more durable than the old one was. She'll never know I broke it. :)
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- rebecca from danville, IN
- Parts Used:
- 131873500
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
Needed New Knob
Got the proper part and it worked great
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Allison from San DIego, CA
- Parts Used:
- 131873500
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Knob broke on dryer
Simple fix; just placed the new knob on the dryer. Fit perfectly. Best part was how quickly the part came in the mail! 2 days later. Very pleased with service.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- kristen from clearfield, UT
- Parts Used:
- 134398300
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
broken stem on on/off switch
just unplugged the old one, plugged in the new made sure it worked and put it back together.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gary T. from Bunn, NC
- Parts Used:
- 131553900
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
heating element went out
first i had a helper my 9 year old son. we came to this site and read a repair report and we used that to go by.once again my 9year old.
Was this instruction helpful to you?
Thank you for voting!