FER231CAS1 Frigidaire Dryer - Instructions

Removed drum and replaced drum support bearing.

Husband is deployed and dd not have $100 for a repariman-So easy !!! Literally put the knob in the correct "D" position and pushed in with a little force. Took about 2 minutes from opening the package to starting my dryer.
Knob is not flush with the dryer-a small space in between knob and dryer but easy fix for $15.

Very easy to do, just take off old knob, and replace by pushing the new one on!

After pulling up the Frigidaire site on internet, there was a video as to how to replace the knob. Very simple to replace. Ordered it and the turn-around time was very fast.

I was surprised that the knob actually broke, and was also surprised at how much the part would cost direct from the manufacturer. The website had a ton of different knobs available, and I'm sure a number of them would have fit. The part showed up in just a few days and fit perfectly. Trying to set the dryer time using pliers makes a person appreciate the proper parts!

My Son-in law did the repair. He removed the top, the front lower panel and finally the front panel with the door. It took a little more time than anticipated because there was not any explicit directions on how much to remove to replace the belt, but he got the job done and put it back together very quickly. Glad I have him to help when needed:).

Got the belt for my little bro's dryer . . . he and a friend tore into it without looking on how to do the job . 2 hours later dryer apart not fixed . . . LoL . . . Next day I get a Call asking me to find a repair manuel . . . I laught and told him to go to Youtube on his phone and the video would tell him how to do it ! He is back up and drying . . . Moral to this story . . . look before you leep !

I used the posts on the site to ascertain the problem (fuze or element burnt out). The pictures were very helpful. I pulled the dryer to the floor and using my meter checked both the fuze and the element. The electrical diagrams were very helpful also. I took the dryer apart further to make sure the coil was indeed the problem. I then ordered the part!

Taking apart cleaning putting back together I don't have any h-t lube so ill be doing it again. Thanks for the part ill be calling again!

first i had a helper my 9 year old son. we came to this site and read a repair report and we used that to go by.once again my 9year old.

Removed obvious screws to the vent etc. Then had a little trouble getting the cabinet open. My only problem was getting the front top panel off. A clip about 2" from either side at the top needs to be pushed in with a flat head screwdriver to release the top. Other than that the task was pretty straight forward. Two sets of wires to the heater itself. Used pliers to help pull them loose.

I watched the video on the web site after selecting the part and it was pretty simple. Everything worked just like the video showed. Probably could have been done faster but I took time to vacuum the inside of the dryer out. Really liked the video.

Dismantled the dryer to determine that the belt was broken. Called a local supply outlet to request a belt. They said they couldn't find one. Did an online search and found Part Select. Called with the model number and within three days the part was delivered. Replaced the belt and the dryer was working within an hour. Hardest part was getting the dryer out of the laundry room. I would certainly call PartSelect again if I needed a part.

Removed access plate in rear, raised top panel, removed two screws holding front panel (with door) put new belt over drum. Threaded belt through path between motor drive and idler wheel. Put everything back together.

My order was shipped very promptly, and was received very quickly. It is wonderful to have this service available on the internet. I can remember how difficult it used to be chasing down parts before. This was impossible in smaller cities.

took off the old one,and the inner sleeve and put on the new one.