Models > DU400SWWW1 > Instructions

DU400SWWW1 Whirlpool Dishwasher - Instructions

Jump to:

All Instructions for the DU400SWWW1
91 - 105 of 244
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Dawn from MELBOURNE BCH, FL
Parts Used:
WP8565925
Difficulty Level:
Easy
Total Repair Time:
1- 2 hours
Top rack broke
I had to replace the whole sliding system on the top rack. Plus the clips holding it. It snapped. I watched the video and did the steps from Steve. The rack slides better than when brand new. Whirlpool wouldn’t pick up phone but part select did. So thank you for being there so I could fix the rack and be able to use the dishwasher again.
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Fred from SICKLERVILLE, NJ
Parts Used:
4317824
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers
Intermittent power loss
Remove power source, then remove old power cord.Run new power cord through existing opening ang attach to existing power box on bottom o f dishwasher. Install electrical leads and device ground. Reinstall cabinet bottom. Check out operation by running a cycle. All ok!
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Diane from LAKE GEORGE, NY
Parts Used:
WP8565925
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
I needed to add a clip stop to the right front track.
I manually attached the track stop to the right track in the disheasher.
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Steve from Mount Pleasant, SC
Parts Used:
4386996A
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
Water leak from the pump housing.
I removed the three screws holding the motor on the housing. Then I took the two hoses off and from inside the washer I unscrewed the ring at the base of the wand that holds the housing in place and removed it. I then replaced the impeller and seals and reversed the process to put it back together. Cost me 26.00 for parts and shipping. I couldnt imagine what anyone else would have charged. I will do business with PartsSelect again in the future.
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
al from Fuquay Varina, NC
Parts Used:
WP8565925
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Socket set
Dishwasher circulation pump malfunction
Tipped over washer, removed attachment bolts, installed new pump by clamping water hoses. Be sure to use proper crimping pliers, not the generic slip joint pliers. Replacement pump included required new clamps.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
George from TEMECULA, CA
Parts Used:
WPW10509257
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
NEW GASKET
I USED A PLUMBER
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Donal from SPRINGVILLE, TN
Parts Used:
4318050
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers
One door spring broken, replaced both
As described with instructions, removed original "bearing," installed replacement, removed original spring, installed replacement springs. Not difficult.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Felix from MELBOURNE, FL
Parts Used:
WP8565925
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Timer repairs
Well, it’s very easy to repair. But, what I like if ur Company is, the availability, of the parts.
Thanks you.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
RONALD from EAST GREENWICH, RI
Parts Used:
W11752368
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
Tines where falling off old rack
The dishwasher is 25 years old. Ordering the part was simple. Very good web site and user friendly. The shipment and delivery perfect. Part arrived as predicted. Tracking delivery was also perfect. Part was exactly what I needed. The only hitch was that there were no instructions for assembly, not even a drawing of the assembly to give a hint as how to assemble. Therefiore assembly took longer than it should have. However the diswasher is back in operation and I am pleased with the results.
5 of 13 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
David from Lisbon, IA
Parts Used:
4386996A
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Screw drivers, Wrench set
pump seal and impeller
had to replace the insides of a leaky pump
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Louis from CHESTERFIELD, MO
Parts Used:
WP3368999
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Screw drivers, Socket set
Dishwasher would not dispense soap
Both springs (8066018 and 3368999) were replaced as recommended in your troubleshooting guide, but did not resolve the problem. Finally the Dual Motor, 3374501, was replaced. During the above, the plastic face of the door fell off, which created a nuisance task before proceeding to fix the original problem. However, while replacing the motor, I realized the purpose of the two, T-shaped studs sticking out of the motor. It is absolutely necessary that these sit inside the slots which engages the sliding plastic cover, which is spring loaded, in order to engage the release of the soap dispenser door. It was truly a learning experience, but I got it done.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Martin from Union Bridge, MD
Parts Used:
WP8268645
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers
Wheel on lower rack broke.
New one snapped right into place.
3 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Deb from LAWTON, MI
Parts Used:
WP8565925
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
front track stop broke on both sides of the upper tray
Very simple to repair The front track stops just slide into place, easy. When I looked for these parts this place was the least expensive and the quickest delivery I have ever had. Quick, efficient and friendly online staffing. Thank you, Deb
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Anita from Weatherford, TX
Parts Used:
W10164258
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
spray arm would not clean
took the old arm off in a minute and replace with the new on,total time about 5 minutes and it now works great
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Curtis from Enderlin, ND
Parts Used:
WPW10509257
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
leaking around door
After cleaning the filter located on top left of door(used a screw driver to pry out) and following the install gasket video problem solved.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the DU400SWWW1
91 - 105 of 244