DU5000XL0 Whirlpool Dishwasher - Instructions

One day after placing my order, replacement wheels arrived. I used a screwdriver to pop each (4 total) old set of tandem wheels off the basket basket and poped each new set on.

Removed old wheels, unclipped. Clipped in new wheels.

The brackets that held the original wheels were still on the rack. They were easily pulled off the rack. The new assembly did not look like the original part. It was not difficult to see how they fit onto the rack. The only caution is to press the top part of the new assembly onto the frame before snapping the rest of the new piece into place.

I pulled the basket out, pulled the cap and connector assembly off with ease, no tools needed, it comes right up, and put the new one on. Put the basket back in and it works great now!

when removing all the screws from the door gasket the dishwasher door and frame separates making reassembly not possible. you have to leave at least one screw on bottom half on each side, After all that the door would not close. I had to remove the new gasket and put the old one back on.
I need to return the gasket for credit

I replaced the seals per the video instructions.

Simply snapped out the old ones and snapped in the new ones. Worked like a charm. Glad you had the parts.

watched a video

the plastic pin that retains the spring has a head on one end that hits a plastic stop on the door to keep it from coming out. I used a small grinder and made a flat spot on the head diameter to make it easy to slide out. This is easier than trying to pry the door off the pin at the two retaing snaps. I was conderned these pin retainer clips were brittle and would break off.
Once the pin is slid out, it is a matter to hold the new spring holes in line with the pin. rotate pin so flat side you ground is turned up, so pin will not move out that way. Tiij about an hour

I called to order two springs and your salespersons were very helpful. The two springs were sent immediately. my husband pulled out our under-the-counter dishwasher and replaced both springs within 30 minutes

Looked at existing assembly and snapped on new one, duplicating existing installation.

Swapped out the old upper dish rack with a new one. A video made the change simple.

after figuring out how to position the door the instructions were good

Snapped in new part

The rack came with pictorial instructions which were fairly veg, however they were to the point. The wheels snapped into place easily, and the center water transfer tube twisted off the old one and twisted on the new one just fine. It is a very good idea to keep the old one out to look at as a guide. There were no instructions on how to remove the transfer tube, I was lucky to have already worked on these before. After that it fits and works just peachy.