66213299K112 Whirlpool Dishwasher - Instructions

Use of black/white pictures made it hard to see part details. Use grayscale insted. Also provide a schematic of the parts involved. The similarity of names made it hard to determine which part was being referred to. used magnifying glass and a lot of trial and error to resolve instalation problems. Second set of rollers went smoother.

Unsnapped old adjusters, new ones went in easy after reading instructions.

Remove old rack adjusters. No removal instructions. Do one at a time. First requires some trial & error until removed. Install new replacement. Instructions not clear because pictures are dark & fuzzy. Again, install one with some trial & error. Second remove & replace becomes very easy.

I disassembled the left side, and installed the new assembly. However, being older and my eyesight not the best, and had assembled it slightly out of position. After adding more light, a magnifying glass. and a much closer look, I found my mistake. I reassembled the unit. The right side only took about ten minutes. I would recommend a larger more visible picture of the unit. I noticed that the units did not roll as easily as the old ones. One must give a slight push to engage the tray into the back of the dishwasher. Had the picture been better, it would have taken only 20 or 30 minutes to assemble.

I removed the old worn parts completely and then, following the instructions and trying to look at the pictures which were very dark and not able to be seen very well, I put the new parts on and replaced the rack in the dishwasher. The repair was fairly simple but would have been easier if the pictures on the instructions had been better.

Took a bit of interpretation to figure out how the piece fit together. Not same as the original. Once i decoded the system, the second side took less than 10 minutes. Fits and works fine.

removed old basket adjuster -installed wheel assemble-installed clips to hold wheel assemble installed adjuster on basket installed final adjuster part with screws supplied--instruction photos not clear and to small -first side took about an hour-the second side took ten minutes -parts work great-anyone with common sense can do the repair

Fairly straightforward install of the kit parts. I was glad to see the new parts were stainless steel and not the weak plastic. I wish I would have known this - I ordered two kits instead of one because I figured it would break again soon. I was very glad to finally find the included screwdriver to torx adapter - I forgot my torx set.

bought the adjuster kit and the hardest part was taking off the old pieces. the new pieces went on very easily and smoothly. I am a female that has done a lot of house projects and this was not difficult at all.

I read through the instructions which actually took longer than actually doing the repair because some of the pictures were a little dark and it wasn't clear exactly which direction the parts were facing. The repair went exactly as the directions said.

Removed broken adjuster by prying open latch tabs. Assembled replacement per instructions. Had to test fit parts due to poor illustrations, compared to other adjuster for correct installation. 2nd side went much quicker

I watched this Youtube film: And it was really easy!

I had left one adjuster on but the new ones were different. I started great but when doing the top part I didn't line up the wire rack with the holes in the upper adjuster plate and found out it was wrong so I had to use the pliers to unsnap the metal piece where they lock in. Once I got the first one complete it only took about 5 minutes to do the other side. The pictures included with the installation sheet were very dark. A you tube video would have been a great asset. It would have made it very simple and easy. In truth, the second side should only take a minute or two because I was only using one hand. My other arm was in a cast because I broke it. Anyone could do this.

Followed the enclosed instructions.

I went on line as instructed by one of your representatives and found clear instructions how to remove old part and put on new one. It was an excellent presentation. It can be found at w10712394 instructions