MDB6658AWQ Maytag Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Barb from TWINSBURG, OH
- Parts Used:
- WP6-918873
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
The silverware basket needed replacement since there were cuts in some places on the bottom which caused utensils to fall partway through.
Very simple. Just replaced the old one with the new one. Voila!!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lane from ITASCA, IL
- Parts Used:
- WP99003149
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Replaced wheel on rack
Snapped new wheel on
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Doris from CONCORD, NC
- Parts Used:
- WP99001443
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
The spray diverter assembly came off and was locater under the rack next to the heating element - heat melted the plastic diverter and lid
My nephew actually put the new part back on for me. The main problem I had was getting both parts of the diverter ordered at the same time. I had to order the lid after the diverter came in the mail! I did not realize it was a two-part replacement piece. I learned later that the lid was a separate part.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Phyllis Van from LODI, WI
- Parts Used:
- WPW10116811
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
old spray arm broke
held spray arm to arm connector and replaced snap retainer, works like a new machine
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Janet from STURGIS, KY
- Parts Used:
- WP6-918873
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Replaced silverware basket. No problems!
Lifted out old silverware basket. Set new basket in. Took approximately 20 seconds.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- betty from GEORGETOWN, TX
- Parts Used:
- WP6-918873
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Basket broke----bought a new one!
opened door---- took out old basket--threw it away. set new basket in its place!!!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- ED from AVENTURA, FL
- Parts Used:
- WP912653
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Door spring linkage broken
Un screwed the dishwasher from the underside of my kithcen counter. Removed the copper water hose(after turning off water valves). PUlled the dishwasher from under counter to expose the hinges. Hung the new linkage on the hinge. Stetched the spring from flange on the bottom of the dishwasher to the new linkage. Reattached hose and reconnected the unit to counter top. Job done.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Denis from JACKSONVILLE, NC
- Parts Used:
- WP6-918873
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Worn out basket
Took old one out And placed new one in dishwasher.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lester L from Edmond, OK
- Parts Used:
- WP912653
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Wrench set
Broken Door Spring Linkage
Turned off the water. Disconnected the water supply line. Extracted 2 screws holding the dishwasher. Pulled out the dishwasher. Changed out the nylon spring link. Pushed the dishwasher back into place. Reattached the water line. Turned the water back on.
Spring linkage and postage about $15.00.
Savings on service call and parts about $175.00. What a deal. Thank you PartSelect.
Spring linkage and postage about $15.00.
Savings on service call and parts about $175.00. What a deal. Thank you PartSelect.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from MILFORD, CT
- Parts Used:
- WP99002106, WP903093
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
The upper tray came crashing down on top of the lower tray because a couple of wheels let go over time.
I ordered the parts after looking at the diagrams. I ordered a total of 5 pieces.
The parts arrive earlier than expected, and were new, OEM, parts. I cannot stress how important it is to order Original Equipment Manufacturer parts.
I replaced the broken pieces within 30 minutes. Great experience.
The parts arrive earlier than expected, and were new, OEM, parts. I cannot stress how important it is to order Original Equipment Manufacturer parts.
I replaced the broken pieces within 30 minutes. Great experience.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from Flushing, MI
- Parts Used:
- WP912653
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Wrench set
Spring assist on door failed,
Removed front access panel
Disconnected water supply
Pulled dishwasher out approximately 1 foot to gain access to spring linkage
Connected new spring linkage to spring, connected other end of spring linkage to door
Tested operation of door
Slid dishwasher back into place, reconnected water supply and front access panel
Disconnected water supply
Pulled dishwasher out approximately 1 foot to gain access to spring linkage
Connected new spring linkage to spring, connected other end of spring linkage to door
Tested operation of door
Slid dishwasher back into place, reconnected water supply and front access panel
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Edward from Pompton Plains, NJ
- Parts Used:
- WP99002069
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
Stinky dishwasher
When I tried to remove the hold down screw for the impellar, the impellar broke in half. I actually did npt need to go this far with disassembly as the problem was with water being retained in the rinse arm assembly and stagnating. This was due to calcium buildup clogging the drain holes. Clearing the holes resolved the problem.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from WENONAH, NJ
- Parts Used:
- 99001454
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
Upper dishrack had rust and corrosion Several upright tines were broken off/
Just slide the old upper dishrack forward to the end. The stops on either slide must be removed . Only difficulty was getting the plastic stops to open up. We used a thin metal knivre to wedge into the opening.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from AMISSVILLE, VA
- Parts Used:
- WP99002560
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Socket set
Dishwasher was overfilling
Remove lower cover, 4 Phillips screws. Remove bracket with float switch, two hex head screws in the rear. After removal pull switch wires, two in plastic housings. Remove float switch, one small Phillips head screw. Remove float switch lever, one Phillips head screw. Clean the bracket and lever. Replace the lever and lube with silicone. Replace the float switch, (new one) and replace wires. Reinstall install bracket with original hex head screws. Replace lower cover. Done.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- William from MORGANVILLE, NJ
- Parts Used:
- WP912653
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
The plastic linkage that connect the spring to the door broke
The time to hook up the spring was a minute or two. I simply attached the linkage to the door and then attached the spring to the linkage.The extra time in the repair was re-attaching the cover.
Was this instruction helpful to you?
Thank you for voting!