MDBCUBEAWX Maytag Dishwasher - Instructions

I'm so happy I ordered these wheels, with them it's running
like new. Without the wheels it was making grinding sounds when it ran. You just push them onto the rack spokes and snap them in place. EASY!

I snapped the old broken one off and snapped the new on.

All I did was put the new wheels on. They were really fast with shipping. I put my order in one day and the parts were there the next.

Pushed them on

Calcium build up from our hard water had plugged varous parts of the dishwasher. Dismantling all the parts for cleaning had resulted in my braking the retaining tabs on the upper sprayer arm, that snaps into a plastic clip that attaches to a flat water distribution tube running from the base of the dishwasher up the back and then over the inside top of the compartment. Replacement is literally a snap. Make sure your get good visualizaton of how to remove the various plastic pieces from the metal or plastic clips that secure them to the inner wall of the dishwasher. Don't do the work only by feel; as I tried to do. Positioning your body to get a good look is, at best, awkward

I installed additional wheels that had broken off. This was on my elderly mother's dishwasher in Iowa. I was visiting from California for a week when I discovered it was broken. I worried about getting the parts because I was not familiar with the area. PartSelect saved me by getting the parts delivered before I flew back to California. It was really great. Thanks,

Screwed new screw onto arm of lower rack
Snapped tine pivots into place

i deinstalled everything in the ground of washer so that i saw the e motor
take of the part from the motor and install your new part
and reinstalled everything

unsnapped the broken piece from the under side of the top rack; assembled new washer arm and snapped back in place under the top rack.

now the dishes come out clean.

followed directions (boring, I know, but it works) on the accompanying video. simple

Followed the straightforward video about the repair. Was not very difficult - great tutorial video.

I watched the youtube video and followed the steps. The first time I tried it without taking the motor out because I didn't want to spill water on the floor, but I wasn't able to tighten the new motor shaft all the way so nothing lined up and it didn't work. Second time I followed instructions exactly and it worked like a charm. This is the second repair I have made to this dishwasher that was given to me for free because the door latch was broken. I fixed that problem for around $12.00. This time it broke because something metal got jammed in the motor causing the threaded shaft to strip. This repair cost around $80.00. Still the cheapest, nicest dishwasher that I could ask for. A+++ for partselect.com on price, service, and delivery. Thanks.

Followed video. Everything went together fine, but leaked water around motor shaft seal. Read comments section on video and someone had the same problem. I had pushed the seal into base too deep. I pulled it out and reseated it. It worked without leaking after that. Bob

I initially took everything out and cleaned everything with the shop vac, and outside with the garden hose. That did not work, so I looked on parts select for a new accumulator filter, as I was not able to clean that very well. To install the new filter, I removed the sliding racks, top and bottom, and the water manifold, then removed the lower wash arm, then the parts under that, the filter plate, the outlet, the impeller, all the way to the accumulator filter. After removing that, installation was the reverse. I also cleaned the middle washing arm, and the lower, as I noticed food particles blocking the outer holes. All is good now, and the dishwasher, which we use almost every day, is working fine.