Models > OEMM1-DU20J-CAN > Instructions

OEMM1-DU20J-CAN Magic Chef Dishwasher - Instructions

Jump to:

All Instructions for the OEMM1-DU20J-CAN
121 - 135 of 372
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Billy from SPRING, TX
Parts Used:
99002254
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers, Screw drivers
Dishwasher would not run unless you pressed very hard on the door and would stop when you released pressure on door.
With watching Video on line it was fairly simply, my son knew exactly what to do, it took him about 20 minutes from start to completion and when tested, dishwasher ran great. We have used it six times and have not had a problem. I would highly recommend this part if you are having the same problem. The video was very good.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Robert from WENONAH, NJ
Parts Used:
99001454
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Upper dishrack had rust and corrosion Several upright tines were broken off/
Just slide the old upper dishrack forward to the end. The stops on either slide must be removed . Only difficulty was getting the plastic stops to open up. We used a thin metal knivre to wedge into the opening.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Robert from Waukesha, WI
Parts Used:
99002254
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers, Wrench set
Door would not lock when closed
Video on website made the repair easy
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
William from MORGANVILLE, NJ
Parts Used:
WP912653
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
The plastic linkage that connect the spring to the door broke
The time to hook up the spring was a minute or two. I simply attached the linkage to the door and then attached the spring to the linkage.The extra time in the repair was re-attaching the cover.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
melvin from CHICAGO, IL
Parts Used:
WP902894
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Leaking in front right bottom corner of dishwasher
I removed the gasket from around the dishwasher. Cleans the grove of any dirt, mold or other debris. I started the gasket replacement at the top center of dishwasher by folding the gasket in half to find the center and inserting that center point into the grove just below the latch.i then inserted the rest of gasket with my thumb into the remaking grove first to the right corner then to the left. No told were needed leak was gone
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Robert from Nashville, AR
Parts Used:
WP902894
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Water leak around door of dishwasher
I removed the gasket from the packaging & soaked it in hot water for approx 5 minutes to enhance the pliability of the rubber. I them opened the dishwasher door and removed the existing gasket, making sure I observed any specifics of the gasket, (ie...shape of gasket). I then cleaned any debris from the gasket channel. I took the new gasket from the water and folded it in half to determine where the middle was, and I started inserting the gasket beginning at the middle area of the channel, (just under the door latching mechanism). I finished inserting both sides and then closed the door for approximately 30 minutes to complete the gasket seating process. No leaks!!!
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Robert from Ashland, MA
Parts Used:
99001454
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Upper rack rusted with many missing tines.
Remove the old rack and slip in the new one. Took 5 min to figure out how to remove the upper rack. Now have "new" dishwasher. Great service by PartSelect.
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Robert from Westminster, CO
Parts Used:
WP902894
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Water leak from the lower area of the door opening
The repair went great. Very simple process to remove the old gasket and just press the new one in by hand. Total time to repair was 3 minutes. This was a very easy process, only needed to use a screw driver and my fingers to do it. The water leak was over. Anyone can do this repair. Don't think about getting a new dishwasher, or a plumber, as this is a very
simple repair that will easily do the fix!
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
thomas from goodyear, AZ
Parts Used:
99001454
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
tines for dishes had corroded
removed the 2 stops that held in the upper basket. rolled the old one out and slid the new one in. the replaced the stops. cake and pie!!
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
William from Lake Zurich, IL
Parts Used:
WP902894
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
door gasket leak
just pulled out old gasket
pushed in new one
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Raymond from Torrance, CA
Parts Used:
99001454
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
The upper basket was falling apart
popped the two end caps off of the runners (the hardest part of the installation was figuring out how to pop them without braking them). Turns out just using a flat screw driver to start opening the cap lock did the trick. Once the end caps were off it was just a matter of rolling the old one off and the new one on and then putting the end caps back on.

The new basket wasn't an exact match, it's lighter weight and doesn't have the exact same configuration as far as the rows of tines. This will do us fine until it's time to replace the unit.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jeff from BURLINGTON, WI
Parts Used:
WP903093
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Wheel axle had broke and the wheel was not connected.
Actually following the online video is the way to go.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Merle from Lowell, MI
Parts Used:
12001383
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Upper keep falling off on washing.
All by hand work, less than 5 minutes of work. Only one part to unscrew remove the spray arm. Then replace it and put screw back on.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Patrick from MURRAY, UT
Parts Used:
WP902894
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
It was leaking out of the front door of the dishwasher
Pride old gasket out with screw driver easily removed it cleaned where the gasket was with mild detergent and easily installed new gasket
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Mary from SPENCER, IA
Parts Used:
99001454
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
worn out top dishwasher rack
watched the video instructions and followed them. ;Very easy.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the OEMM1-DU20J-CAN
121 - 135 of 372