6651744994 Kenmore Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Steven from Woodstock, IL
- Parts Used:
- 4386996A
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Pliers, Screw drivers
Leaking where motor drive shaft enters pump
Remove lower rack in dishwasher, remove dishwasher, lay dishwasher on it's back, remove and replace motor and pump.Install new impellar with new seal. reconnect water, electrical and drain hose. Easy Peasy
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Richard from Hendersonville, NC
- Parts Used:
- 676413
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
Latch on soap dish was broken and needed to be replaced
The video was of great help. One area that gave me grief was placing the small part with points under the plastic mechanism in the door. I tried to push the points into the open slot. After watching the movie a few more times I was trying to put the part in backwards. A little more explanation at this point in the video would have been a tremendous help. Otherwise, thank you for the video.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Randy from Soldotna, AK
- Parts Used:
- WPW10509257, WP596669
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Leaking during cycle
I replaced the seal, still leaked. Once I noticed that it was only leaking from the left side, we did a Google search to find that the screen in the upper left of the door could be the issue, causing back pressure. Once the screen was cleaned, no more leaks.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from Lecant, FL
- Parts Used:
- 4386996A
- Difficulty Level:
- Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Screw drivers
Water not draining out of dishwater completely
I read everyone else's fixes, which were very helpful but my solution of removing the plastic from the motor shaft was a lot easier than others. I simply used side cutters and made two cuts into that plastic piece and it Fell of. much easier than the person using several Dremmel blades to cut it off.. That was the most difficult phase until I grabbed my ole phone company side cuts and just cut it off in 15 seconds. Thanks for all the other tips. I love dealing with Parts Select, Fast and efficient. Jim W
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sallie from Ahwahnee, CA
- Parts Used:
- 4386996A
- Difficulty Level:
- Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Pliers, Screw drivers
Not draining completely
Unplug dishwasher from electrical, water supply and drain hose. Pull dishwasher out from under cabinet. Unscrew water whirler from inside washer, then remove motor. Remove black boot from motor. Unscrew keeper from impellor housing. And you are there! Pull impellor off motor shaft. Replace seal first, then replace impellor. So easy this girl did it. But, this girl also does small engine repair!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- lawrence from brookings, OR
- Parts Used:
- WP3369020
- Difficulty Level:
- Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Nutdriver, Pliers, Screw drivers, Wrench (Adjustable), Wrench set
water leak
Got on the computer, located your site and read the repair stories.Thought, I can do this. Ordered the impeller and seal kit. I followed the same procedures as your other customers, however, when I turned it on for a test it still leaked. Went out looked for a new dishwasher, for $389.00. After talking to my wife,(been married over 60 years)decided to try one more time. Went through the same steps. Loosen the plastic ring remove The revolving spraying arm, tipped on the front to get to the bottom. mopped up the water,disconected water, electric, and hoses. Pulled the motor and pump unit, disassembled the pump unit,then I realized I had installed the rubber and plastic bearing backwards. The rubber to rubber wore out real fast. Ordered a new seal kit (no impeller) Put it all back together and it works just like it did 19 years ago. Total cost less than $60.00. It is a good feeling when your able to fix somthing like this, especially ehen your a fat 83 year old. I would like to meet the person that changed this in a half hour.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sharon from Ankeny, IA
- Parts Used:
- WPW10509257
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
leak at left side bottom of door
took out old door gasket replaced it with new, also cleaned the air vent at top of door. Ordered shield at same time but didn't use it, so returned it, haven't received refund yet, but expect one soon. Dishwasher works great and NO leaks. Wonderful website
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gary Scott from Bonham, TX
- Parts Used:
- W10161215
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
the tips of the rack were rusting.
Received new rack in record time(very impressed with the delivery time)installed one part for the removable rack in the rear and simply replaced the old with the new.
Was this instruction helpful to you?
Thank you for voting!
Broken Hinge Lid Pin and Lid Spring
I followed the video's from Parts Select and it took me less than 3 minutes to replace these parts. I did find it easier to use a screwdriver to lift the u shape of the spring over the detergent cup as the pliers tended to pull on the spring too much. Couldn't have been easier or faster, awesome!
Was this instruction helpful to you?
Thank you for voting!
The soap dispenser lid spring was broken.
I watched the video, which was very good, and did the repair. It took about 10 minutes. Most of that was watching the video. EXCELLENT VIDEO!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kenneth from East Providence, RI
- Parts Used:
- WPW10509257, WP8528862
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Water leaking from door
Just followed the online instructions. I used white vinegar to clean any residue first. So easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Norm from Hamilton Square, NJ
- Parts Used:
- WPW10254672
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
A gift portable dishwasher did not have the faucet adapter.
Found the adapter on Parts select through a google search. Unscrewed the existing faucet aerator and srewed in the adapter. The plastic shrink wrap holds the washer and screen in place, so don't open it until you're ready to install. Finger snug does it, only use the pliers to remover the old aerator from the faucet. Normally, I don't use pliers, but both of these parts were round and had vertical serrations to engare the plier teeth.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Todd from Sylvania, OH
- Parts Used:
- W10161215
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Rusting lower rack
Replaced the lower rack. The replacement part had the wheels attached. No assembly required.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mary Ann from Menahga, MN
- Parts Used:
- WP8528862
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
water leaking from bottom of door
removed the 2 water deflector and slipped the new ones in , in place.. very easy to do but it didn't seem to stop the leak so ordered the door gasket
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Becky from Stanley, NC
- Parts Used:
- WPW10254672
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Wrench (Adjustable)
The Faucet Adapter was worn out.
Ordered a new Faucet Adapter! Simple
Was this instruction helpful to you?
Thank you for voting!