HLD4040NS General Electric Dishwasher - Instructions

i needed new rollers and inserts to keep wheels on now its like new when i pull out bottom basket

Simply replace wheel

just snapped the new part in. couldn't have been easier

Parts were easy to find, easy to order and arrived prior to the advertised delivery date. Instructions for replacement were easy to understand and in about 10 minutes the old part was removed, and the new one installed. thanks for your prompt and efficient company.

Remove bottom articulating sprayer and water fittings. Remove and replace filter

Removed screws that held dishwasher under cabinet...pulled out DW...removed old part...replaced with new....easier than falling off a stump.

first off if you can understand the problem DO NOT CALL THE GE REPAIR SERVICE AND HAVE A REPAIRMAN COME TO YOUR HOME you will save over $300.00. a mistake i made, it cost me $79.95 just for him to tell me the dishwasher was broken and then i was told it would cost me over $300.00 to fix it. WHEN I TALKED TO PARTSELECT I FOUND THE WATERVALVE FOR A LITTLE OVER $55.00 WITH SHIPPING IT TOOK ABOUT 20 MINUTES TO DISCONNECT THE DISHWASHER AND REMOVE THE OLD PART AND ABOUT THE SAME AMOUNT OF TIME TO REPLACE THE NEW ONE THEY EVEN HAD GOOD INSTRUCTIONS IF YOU NEEDED THEM. I FOUND PARTSELECT SERVICE TO BE A VERY GOOD BUSINESS TO WORK WITH. ROY F BURTNETT

I carefully read over comments from other people's experience first. I removed all the screws from the inside panel and had several heavy books to weigh down the door. This allowed me to remove the white inside panel, turn it to get easy access to the seal at the bottom. All that was necessary was to clean the area of builted up soap etc, start pulling old seal off from one side and at the same time insert the new seal in same track and groove, being careful to have the new seal lined up in the same manner as the old. The whole process was rather simple and required very little effort.

My wife said the door broke; we need a new dishwasher. It is not worth a $100 repair out of warranty. I checked this site the springs were about $4 each. When they arrived I unscrewed two screws holding the dishwasher to the counter; carefully pulled the dishwasher out from under the counter; found the broken spring replaced it and for good measure I also replaced the old working spring on the other side. The door now works fine. Total time less than a half an hour.

Unscrew the inside door from the outside door. remove the old control switch, insert the new switch, screw the door back together. Hint-buy two switch interlocks as our first repair only lasted a year....it broke the day we were expecting company for a week...alot of dishes to do while we waited for the part! Easy repair- don't be afraid!

Easily screwed on this part and used it for the door of the dishwasher to properly open and close

After reading other customer responses I decided to attempt the repair myself. After pulling out dishwasher I turned it on it's side and prodeeded to remove the 3 screws holding it in place. FIFTEEN minutes later I pushed it back into position and it has performed like new for the past month. Comparing parts and service I saved about $200.00 on this self repair. I would not hesitate to undertake another repair after my experience.

im 73 years old and a lady did it myself very easy

I unscrewed all the screws from the inside of the dishwaher door. I took out the broken part, installed the new parts and screwed the screws back in. Part Select was wonderful to work with and the parts arrived the day after they were ordered.

Replaced the water-fill solenoid valve.