PDW1800N02BB General Electric Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Calvin from Mankato, MN
- Parts Used:
- WD12X10122
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
aid cap melted
Twisted new one in place of old. Disappointed that there was a melting issue at all. Need to investigate problem.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Crown Agents USA from Washington, DC
- Parts Used:
- WD12X10231
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Wheels Had Fallen Off
The wheels on our bottom tray to our dishwasher had fallen off from a lot of use here in our office. When the wheels arrived, I just simply snapped them back on. A few had to be snapped on tight, but there were no tools necessary. Overall, a very easy fix.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Danielle from Fort Edward, NY
- Parts Used:
- WD12X10231, WD12X10230, WD12X10221, WD08X23648
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Seals and Wheels
It was really easy to find the parts in the diagram your website provided. Youtubed the repair instructions....done....thank you very much
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Scott from Newark, OH
- Parts Used:
- WD12X10231
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Studs had become worn and needed replaced
Removed all wheels, then removed and installed new studs which were designed better than the origional and re-installed. Bottom rack now slides in and out much better.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Nonie H from Kitty Hawk, NC
- Parts Used:
- WD12X10231
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
the lower rack wheels were breaking
I was able to replace the wheels with the new ones I ordered which are a better design.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Martha from Kingman, AZ
- Parts Used:
- WD12X10122
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Rinse Dispenser Cap melted on heating coil
Opened dishwasher after it completed a wash cycle. Found the rinse dispenser cap had come off during the wash and melted on the heating coil at the bottom of the machine. Pulled cap off of coil, made sure coil was not disturbed. Looked in various sites for cap. Finally found this site where I didn't need to order the whole mechanism and could order just the cap. Received the cap, screwed into the dispenser, fixed. The only problem I had was that there were two possible caps so I picked the one that was the same color as the original one. Project completed. Thanks
Was this instruction helpful to you?
Thank you for voting!