Models > PDT750SSF7SS > Instructions

PDT750SSF7SS General Electric Dishwasher - Instructions

Jump to:

All Instructions for the PDT750SSF7SS
61 - 69 of 69
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Teresa from Grand Bay, AL
Parts Used:
WD22X22857, WD21X10519
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver
Dishes not drying on top rack
Going by another review on this site, I used a 1/4" nut driver to remove the 2 hex head screws at the base of the flood switch. I used a clothespin/bag clip to hold harness out of the hole when disconnecting the flood switch. It was easy to plug in new switch. I cleaned out the base where the O-ring goes to make sure it will seal properly. Had already changed out the heating element and the tub gasket but still had issue with the dishes not drying in the upper rack. Another review here did bring up the flood switch as possible problem so I changed it. This solved the issue. So the primary problem was the flood switch. Very thankful for your Q&A section for the parts.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Donald from WILLIAMSBURG, VA
Parts Used:
WD22X22857
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Spray arm removal.
Read up on part at manufacturers web page and installed replacement correctly.
2 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the PDT750SSF7SS
61 - 69 of 69