GSD2800D01 General Electric Dishwasher - Instructions

Installed new lower rack wheel kit

I used the pump/motor replacement kit. It was a very easy repair and the parts were a direct replacement with no modification necessary. I saved over $300.

Removed all 8 wheels and inserted the new one after inserting the axles into each wheel. Replacement wheels had a much better connection to the bottom rack and do not anticipate any problems in the future.

UNPACKED WHEELS AND CLIP. USING NEEDLE NOSE PLIERS SQUEEZED WHEEL TIP TO INSERT IN WHEEL. REMOVED OLD WHEELS AND RETAINER BY HAND. INSTALLED NEW WHEELS INSTALLED AND NEW RETAINERS

removed relay and replaced, found moth cacoon inside relay. Goodman a/c not3m no goodman in list

I removed the screws from inside door panel. Took door panel out. Noted the way the old gasket was placed, removed it and replaced with the new gasket. Replaced the door panel. Felt pretty proud of myself until I realized that the door lock wouldn't work when I was going to run it. I have now removed the door panel again and am trying to get the door lock lever to work.

Open door, remove lower wash rack, remove 4 screws holding screen in rear of inside tub with 1/4 inch socket. Unscrew piston and nut assy for checkvalve, sounds like a mouthful but it is only 1 part. Checkvalve has 2 small ears on it which allow you to twist it out, it has treads on it. Flapper on check valve flapper rots away and water pumps back into tub instead of being routed to drain line to garbage disposal. Part with shipping was just over $20.

removed both corner baffles, also door gasket was bad, all parts were easy to order and install, the customer service was excellant with all my questions and concerns to get the right part and the parts arrived in just two days, thank you

researched the problem, listened to you tube, ordered the parts
and did the repair. Very easy to do, only took a few minutes.

Took out old one and put in the new one. Not hard at all. Thanks

Removed the 7 screws from inner side of door; removed set screw from handle; removed inner door cover; pulled old part out; pushed new part in and Voila! Replaced all screws, no problem. Thanks for your great customer service!

Removed the corner baffles by lifting up and out. Cleaned the area and pushed new replacements in position.

Removed door seal by pulling on the end.
Press new seal in to the slot. Work in to slot a tree ound door.

With a flashlight under the dishwasher, I saw a thin stream of water coming from a hole in the flexible connection between the pump discharge and the bottom of the tub, called a “lower spray arm connector”. I removed the dishwasher from the counter (very easy) and laid it face down on several towels--a good idea because water would leak out from various cavities. The pump also came off easily—just a few screws and clamps. The hard part was removing the old connector, since it appeared to be stuck in place. So I cut it off with a hacksaw, with a fair amount of difficulty. What I didn’t know was that all I needed to do was twist the lower spray arm base inside the tub to release the connector. It was obvious once I cut out the old one. Assembly was easy and the leak is now gone.

Ordered motor and pump and replaced. Motor pump kit also comes with a drain solinoid so if that was the problem the kit repaired it. One issue is the size of the hanger to ensure the pump does not just hang on its mount. The directions were not very clear and after some trial and error I got it to work to.

The rack for my model has been discontinued so they shipped me the replacement version. The wheels on the new one are skinnier than the original model so I had to remove them and replace them with the wheels from the old rack for it to fit/roll correctly. The new wheels were a little tricky to get off as I had to use a screw driver and basically manipulate/pry apart the clamps that hold them on. The old wheels just snap on.