Models > ZBD1850N03II > Instructions

ZBD1850N03II General Electric Dishwasher - Instructions

Jump to:

All Instructions for the ZBD1850N03II
31 - 42 of 42
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Scott from Newark, OH
Parts Used:
WD12X10231
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Studs had become worn and needed replaced
Removed all wheels, then removed and installed new studs which were designed better than the origional and re-installed. Bottom rack now slides in and out much better.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Nonie H from Kitty Hawk, NC
Parts Used:
WD12X10231
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
the lower rack wheels were breaking
I was able to replace the wheels with the new ones I ordered which are a better design.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Mary from Rocky River, OH
Parts Used:
WD12X10231
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Lower rack wheels kept falling off on right side
Definately purchase all the wheels (8) as they are smaller than original wheels. Buy the wheel with attached stud. Pull off old wheels and pop these on!
Was this instruction helpful to you?
Thank you for voting!
Customer:
Martha from Kingman, AZ
Parts Used:
WD12X10122
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Rinse Dispenser Cap melted on heating coil
Opened dishwasher after it completed a wash cycle. Found the rinse dispenser cap had come off during the wash and melted on the heating coil at the bottom of the machine. Pulled cap off of coil, made sure coil was not disturbed. Looked in various sites for cap. Finally found this site where I didn't need to order the whole mechanism and could order just the cap. Received the cap, screwed into the dispenser, fixed. The only problem I had was that there were two possible caps so I picked the one that was the same color as the original one. Project completed. Thanks
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the ZBD1850N03II
31 - 42 of 42