Models > 1071-003A > Instructions

1071-003A Frigidaire Dishwasher - Instructions

Jump to:

All Instructions for the 1071-003A
61 - 75 of 75
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Kevin from Old Orchard Beach, ME
Parts Used:
154106202
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers, Wrench set
My dishwasher was leaking from and electrical connection at the heating element
There was an excellent "how to" video on the internet which also pointed me to the part I needed. I did not even remove the dishwasher as recommended. I removed the lower kick plate, removed the power connector at the leaking input, removed the bad nut and installed the new nut.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Robert from Oak Harbor, WA
Parts Used:
154106202
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers, Wrench set
Brass Nut Cracked - Water Leaks O Floor
I removed the 2 screws that hold the dishwasher in place. Slide out the unit just far enough to access the brass nuts on the heating element. Pulled off the wire, and replaced the broken nut with the new nut. Replaced the wire, slide the unit back into place and reattached the 2 under counter screws. Done!!!
Was this instruction helpful to you?
Thank you for voting!
Customer:
Edward from Bristol, RI
Parts Used:
5300809703
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
Broken Door Counter Balance Springs
Removed lower panel; unmounted fill valve assembly. Installed two springs. Remounted fill valve assembly and reinstaslled the lower panel. Door must be in a near closed position to gain access to the door "L" spring brackets.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Nancy from Ocean Park, WA
Parts Used:
5304535381
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
upper dishrack would not stay in place
Ordered the new roller assembly and in no time the upper rack was back together, up and running. Now to see about replacing the other two rollers and the side rails as they are showing wear and tear.

Thanks for the quick ship.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Sharon from South Park, PA
Parts Used:
5304532229
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
original rack wheels where bent and upper wheels had melted
husband replaced wheels.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Matt from Salisbury, NC
Parts Used:
154106202
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
(leaking) heater element nuts cracked under dishwasher
power off, take off kickplate, unplug 2 wires and unscrew broken nuts, put new nuts on, plug wires back in,(run dishwasher one cycle to make sure no leaks) put kickplate back on, power on.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the 1071-003A
61 - 75 of 75