1071-003A Frigidaire Dishwasher - Parts

This heating element mounting nut is used in dishwashers and is used to hold the nut to prevent leaking. If your nut is damaged or you notice leaking from the dishwasher, then replacing this nut will ...

NOTE: Sold individually. This door spring is four and a half inches long. It is used for some dishwashers. These springs tend to wear out at the same rate, so you should replace both of your dishwashe...

Sold individually.

This is a basket for your dishwasher. It sits in the lower dishrack and holds small utensils during a washing cycle. This basket has six smaller sections where you can separate your cutlery into speci...

Sold individually.

This electrically operated propeller causes water to flow through your dishwasher's pump. This impeller is located above the dishwasher's mascerator blade.

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

This white rinse aid cap is a little over two inches long. It comes with a black rubber gasket, and is used for some dishwashers.

With this macerator blade it chops up/mince the food particles in the collection chamber to prevent from clogging the dishwasher pump.

This black pump housing spacer plate is a little under four inches long.

This pump motor shaft seal will help prevent the water inside the dishwasher from leaking around the shaft of the motor.

Holds the spray arm onto the diffuser assembly.