F71C765BS0 Frigidaire Dishwasher - Instructions

Snapped new wheels into place on the axel. New wheels were exactly like the old ones

I pulled the old door gasket out, cleaned the guck out and pushed the new one in it's place.

So easy it shouldn't even count as a repair, really. The dishwasher, there when I bought the place, had a lower rack that wouldn't roll out as it should. That's because there were no wheels on the left side.

The rack lifts out easily. These wheels snap on to small protrusions from the wire rack.

I had to replace the door gasket but it would not go in very easy..So I put the gasket in a sink of warm water so it would be more pliable. Then it went on fairly easy.

Two rollers on the lower rack were missing and one was flattened. I popped off the bad roller and snapped the three new rollers in place, all by hand. Took about 60 seconds.

This could not have gone easier! As long as you get the proper parts it's a piece of cake. I wish everything was this easy!

Fisrt, I opened dishwasher door. I then pulled out the lower rack & put new part in place and pushed in lower rack. Last, I closed dishwasher door.

Both heating element brass nuts had a split in them. They had fallen off the heating element and were hanging on the electrical wires. I removed the wires from the heating element and removed the brass nuts from the wires. I then screwed the new nuts on the heating element and reattached the wires. problem solved. I want to thank you for having the parts I needed as Sears had discontinued them for this Kenmore appliance.

merely snapped the part on

Installed New rollers onto bottom rack. Part order & delivery were top notch from Partselect. Will definitely order from them again.

Rollers just snapped on the diswasher rack. Took just seconds to do.

There was an excellent "how to" video on the internet which also pointed me to the part I needed. I did not even remove the dishwasher as recommended. I removed the lower kick plate, removed the power connector at the leaking input, removed the bad nut and installed the new nut.

removed wire rack -removed nut from bottom sprayer-turned impeller housing CCW- removed screw from impeller -replaced impeller and tighten screw replaced other part and stared dish washer repairs were complete and now i have clean dishes

This is a case of weak OEM design. Substantial (cup) weight placed on the rack will ultimately cause these wheels to break under load stress. My fix went slightly beyond the design by installing 8 cents worth of washers between the wheel and the screw head. That way any slack was reduced so that the wheels were less stressed at an angle. The rack now sits square and the wheels more true than design. I picked up some lock washers at local hardware store and flattened them out to fit smooth. The parts supplied by PartSelect were perfect fits to OEM. This is a truly easy repair. If your top rack keeps falling off the guides due to broken tub wheels this will take care of the problem. I will add that the parts that you can obtain through PartSelect are adequate without improvising. I just went for a more robust fix to the original design with additional washers. Hope this is helpful.

Ordered the new roller assembly and in no time the upper rack was back together, up and running. Now to see about replacing the other two rollers and the side rails as they are showing wear and tear.

Thanks for the quick ship.