GDPP4515AF0A Frigidaire Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- John from Metairie, LA
- Parts Used:
- 154106202
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Wrench set
dishwasher was leaking at heating element connections
Both heating element brass nuts had a split in them. They had fallen off the heating element and were hanging on the electrical wires. I removed the wires from the heating element and removed the brass nuts from the wires. I then screwed the new nuts on the heating element and reattached the wires. problem solved. I want to thank you for having the parts I needed as Sears had discontinued them for this Kenmore appliance.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Allan from Portland, OR
- Parts Used:
- 154827601
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Dishwasher was leaking
Had a leak, due to the factory gasket was 1/2 " to short. Pulled out old one, installed new one, and trimed to fit. Took less the 5 minutes.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Clarence from Gerald, MO
- Parts Used:
- 154827601
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
dishwasher leaked around the door
My Son used needle nose pliers to remover the old gasket, then starting on the lower right side, inserted the new gasket and used the rounded end of handle of a wooden spoon and pressed the gaste in place by running the handle up and around the top then down the left side. Used sissors to cut the new gasket to length. Door fit very tight. Ran a normal wash cycle and no leaks.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from Hammonton, NJ
- Parts Used:
- 154827601
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
Leaking at the door
I just pulled the old one out and installed the new.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dean from Boscobel, WI
- Parts Used:
- 154827601
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
dishwasher door was leaking.
Pulled out the gasket,trimmed the gasket to fit and alittle pressure to put.it in place, very easyto do. No worries any one can do this and savek yourself costly repair person.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Roseana from Virginia Beach, VA
- Parts Used:
- 154827601
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
The close door code kept going off and was leaking on the bottom.
Took the gasket off and put the new one on.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mahlon from Kirby, TX
- Parts Used:
- 807117001
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
Rat chewed thru the drain HO9SE
pULLED THE WASHER FROM THE COUNTER disconjnected the house from the garbage disposal connected thenew hose to the disposal, remove other end of old hose from thedishwasher and replace with the new drainage hose.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from Oak Harbor, WA
- Parts Used:
- 154106202
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Wrench set
Brass Nut Cracked - Water Leaks O Floor
I removed the 2 screws that hold the dishwasher in place. Slide out the unit just far enough to access the brass nuts on the heating element. Pulled off the wire, and replaced the broken nut with the new nut. Replaced the wire, slide the unit back into place and reattached the 2 under counter screws. Done!!!
Was this instruction helpful to you?
Thank you for voting!
Dishwasher would not pump water out
After looking at several youtube.com remedies, I zeroed in on the problem... non-functioning waste water pump. I also noted that the valve flapper was in rough shape so ordered both. Once I got the new parts, I replaced the old ones in less than 30 minutes. When I removed the old pump assembly, I discovered that the four-blade waste water wheel had broken off. For about $75, I repaired what no one in my small rural town could. I think the retail on the dishwasher was somewhere between $300-350, so I figured it was a good deal. Also I scored BIG man points with my wife!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Thomas from South River, NJ
- Parts Used:
- A00126401
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Water would not drain from dishwasher
Disconnect drain hose, disconnected power, laid dishwasher on its back. Had to remove wash motor, then had access to the drain pump. Removed bad drain pump, installed new drain pump, reinstalled wash motor, reconnected drain hose, then reconnected power. Job is done working as intended. Really easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Steven from Wauwatosa, WI
- Parts Used:
- 807117001
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Socket set
Had to replace the drain hose (that I screwed up)
I already had the dishwasher removed for remodeling. I wrecked the drain hose myself. When I received the replacement it was a breeze to install.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- jeff from beach park, IL
- Parts Used:
- 5304523304
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
dishwasher would stop after about one minute and give a code on the screen
Looked up the code on the internet and it said it was the vent fan, was easy to pull out and replace. Saved hundreds
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- willis w from broomes island, MD
- Parts Used:
- 154827601
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Door Leaking
All I have to say is paets select is the best company I have delt with in the last 20 years
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Matt from Salisbury, NC
- Parts Used:
- 154106202
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
(leaking) heater element nuts cracked under dishwasher
power off, take off kickplate, unplug 2 wires and unscrew broken nuts, put new nuts on, plug wires back in,(run dishwasher one cycle to make sure no leaks) put kickplate back on, power on.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- BOB from MERRIMAC, WI
- Parts Used:
- 5304523457
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
leaking water inlet
removed old hose by loosening clamps replaced hose reclamped
Was this instruction helpful to you?
Thank you for voting!