Models > FFID2426TS5A > Instructions

FFID2426TS5A Frigidaire Dishwasher - Instructions

Jump to:

All Instructions for the FFID2426TS5A
121 - 135 of 251
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Catherine from CYPRESS, TX
Parts Used:
5304533200
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
bottom dishwasher rack had melted prongs
I put in the new rack but discovered it only has prongs for a few dishes the rest of it is flat with NO prongs. So it doesn't really work.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Michael from STEWARTSVILLE, NJ
Parts Used:
5304532229
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Missing part
Just pushed it onto the rod that held the old one
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Andy from Grass Range, MT
Parts Used:
5304507158
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
The top part of the lower spray arm got stuck on something a broke off the lower part of spray arm.
The are 2 tabs on the bottom of the lower spray arm that I pushed in and the arm popped right off. All you have to do is push the new spray arm on until you hear it snap into place, and you are done. It is really easy to do, and the part fit perfectly.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Sally from SPRINGFIELD, VT
Parts Used:
140229954072
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
PRONGS WERE RUSTY AND PULLING THE RACK TO LOAD, RACK FELL DOWN.
Ordered a new upper rack, My husband installed in less than 10 mins. Good to go. So easy.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Bob from Clinton, OH
Parts Used:
154827601
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Leaking tub seal
Just pulled the old gasket out and popped in the new. I did trim it too shrt however so be careful not to do that.
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Robert & Kathleen from FAIRFAX, VT
Parts Used:
154579101
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Door springs were stretched; with one broken
Followed the on-line tutorial. BINGO!!!!
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
John from SUNBURY, PA
Parts Used:
154579101
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers
Left door spring had stretched and no l held the door upright
Opened the package and inspected the new spring
Went to Part Select site to read directions
shut off the power
Reached under the dishwasher and disconnected the old spring from the frame
detached the old spring from the pulley cord
attached the new spring to the pulley cord
reached under the dishwasher and attached the new spring to the frame
Turned the power back on
total time around 15 minutes including reading the instructions
Piece of cake!
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Joseph from WOONSOCKET, RI
Parts Used:
5304519906
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
My dishwasher wasnt washing the dishes.
I had to remove the dishwasher and lay it on its back. But after that I swapped out the pump, put it all back together, and I was good to go.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jimmy from COMSTOCK PARK, MI
Parts Used:
154825001
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Wrench set
My heating element was cracked
Remover the cracked heating element with the new heating element.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Rita from MEDANALES, NM
Parts Used:
5304523457
Difficulty Level:
Very Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
Dishwasher Sprang a Huge Leak
I pulled out the dishwasher and found the inlet tubing had a tear in the accordion part of the tube. I searched online for the model number and was directed to PartSelect. I ordered the inlet tubing, and it only took a few days to get to me. I then watched the video and was able to install the new tubing.

PartSelect is a life saver and I saved lots of money by not having to call a repairman.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Hank from Fort Pierce, FL
Parts Used:
5304506521, 807145201
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
Making noise during operation.
Checked your videos and found the lower spray arm damaged (nubs worn down). Previous owner had some work done and didn't reinstall the parts properly. While during the repair, I also decided to replace the Detergent Dispenser and make a new spray shield. I guess the previous owner decided one wasn't needed.

Easy install, no noise.

Capt. Hank
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Robert from DENVER, NC
Parts Used:
5304507158
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Lower arm broken,
Replaced lower arm
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Leonard from N ROYALTON, OH
Parts Used:
154825001
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Wrench set
The heating element (ring) showed signs of wear
I followed the steps on YouTube.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Richard from Upperco, MD
Parts Used:
154106202
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Wrench (Adjustable)
Small Constant Drip (Leak)
I pulled out the dishwasher removed the two heating element insulated wires and removed both threaded brass nuts and replaced them both. Problem solved. Luckily I have a local parts and repair store with a repairman that knows every part of every appliance ever made (no kidding, I have yet to stump him with a part or question). He did not have the parts, told me to go to partselect.com order two nuts, replace them both at the same time, and fix it myself because its an easy repair and not worth paying hundreds of dollars, if you can use a wrench. He was right, and partselect.com had the right parts, at the right price, easy to find and order, and I can impress the wife with my repair skills. Thanks again!
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jonathan from Falls Church, VA
Parts Used:
5304532229
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Half the wheels were missing from the lower rack.
So easy it shouldn't even count as a repair, really. The dishwasher, there when I bought the place, had a lower rack that wouldn't roll out as it should. That's because there were no wheels on the left side.

The rack lifts out easily. These wheels snap on to small protrusions from the wire rack.
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the FFID2426TS5A
121 - 135 of 251