DDW361RAW Amana Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Brad from York, ME
- Parts Used:
- WP902899
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Dispenser door would not open
Attempted repair was quick & simple. Removed 7 torx screws, and then pulled the wax motor out of its holder. Pulled 2 wires off, and replaced old motor with new motor. Reattached wires, & reassembled.
Only problem was this did not fix the problem, so back to square one, but worth a shot.
Only problem was this did not fix the problem, so back to square one, but worth a shot.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Carrie from Platteville, CO
- Parts Used:
- 902882
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- Less than 15 mins
our dishwasher needed a motor shaft seal
I recieved a different part than was in the picture and description that I ordered, and was billed twice for it. I wasn't able to fix my dishwasher
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Elizabeth from Costa Mesa, CA
- Parts Used:
- WP99001576
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Silverware basket falling apart
Ordered new part from your site. The new basket arrived in just a few days, without the handle and cover for the small item section. Instructions with with new basket described how to remove the other parts from the old basket and install them on the new one. Everything worked out perfectly and my silverware stays put. I've very happy!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Paul from Gibsonia, PA
- Parts Used:
- WP99002003, 99001290, WP902894, WP99001553
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
Dishwaser Leaked onto the floor
The repair was very easy. The door gasket was a little short, but I gently streched it to the proper length. I replaced the other parts as a precaution as some others said they were really the source of the original leak. It went very smoothy and NO MORE LEAKS.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- frank from mountain home, AR
- Parts Used:
- WP99001359
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers, Wrench (Adjustable)
no water entering the dishwasher
Shut off the water and electric then removed the cover at the bottom then removed the water inlet valve and replaced it with the new one. Turned on water and electric. Replaced cover at bottom. Very easy and the part was shipped quickly. No problems and the dishwaser works great now!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Judy from FENTON, MI
- Parts Used:
- W10139223
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
lower rack rusted through all over
Took rack out of box, son removed water tower from old rack, put it on new rack, rolled new rack into dishwasher. Presto! Done!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Elizabeth from CHEEKTOWAGA, NY
- Parts Used:
- WP902894
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
When I would run my dishwasher, water would pool on the right side front of the washer. It was even dripping down into the basement. When I figured out it might be the the front door gasket, I ordered the part.
The repair was very easy! I simply pulled out the old gasket from around the front part of the dishwasher. I cleaned the area with a damp rag from any residue that was left on. I bent the long gasket in half and and pushed it in starting at the center of the dishwasher and went down one side at a time until the whole gasket was in. I then ran a short cycle on the dishwasher to make sure it was properly in place and the problem was fixed. NO MORE WATER ON THE FLOOR! I was so very happy to know my problem was fixed and I didn't need to buy a new dishwasher! It's been running great! :) ~ Elizabeth ~
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- gary from Tunkhannock, PA
- Parts Used:
- Y912923
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
bad cap
no problems, very easy
Was this instruction helpful to you?
Thank you for voting!
The racks were very rusted and falling apart.
Just undid the brackets holding the top rack in place and put in the new racks, locked the brackets and in the bottom put the water tower on and slid that rack in place, and bam we were ready to turn it on. It's wonderful, all new and clean. LOVE IT!!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bernadette from Glen Cove, NY
- Parts Used:
- WP902894
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
leak at bottom left and right side
pulled out the old gasket, cleaned the area before pressing in the new gasket with my fingers ,I made sure to put it in the same way as the old one. You have no idea how happy I am that this solved the problem.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Teresa from Terre Haute, IN
- Parts Used:
- WP902894
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
My dishwasher was leaking from the bottom right hand corner.
I removed the original gasket, wiped down the area, and installed the new gasket the same way the old one was installed. It was very easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- gregory from Staten Island, NY
- Parts Used:
- WP6-917075, WP99002069
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver, Screw drivers
ratteling noise
unscrew screen and cover and unbolt impeller replace with new parts. everything goes back together easily, anyone with even minimal repair skills should be able to do this repair.
Was this instruction helpful to you?
Thank you for voting!
Rust and corrosion on the dishracks
I removed the bottom rack by simply rolling it out of the dishwasher, and removed (unsnapped) the rotating spray assembly. It was easily snapped into the center of the new dishrack. Next, I removed the roller stops from the rail holding the upper dishrack by following the marks (arrows) on the stops. I rolled out the upper dishrack, and rolled in the new one. Finally, I snapped the roller stops back into position.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- joseph from goffstown, NH
- Parts Used:
- WP902894
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
washing machine leaked at right lower corner
removed old deteriorated gasket - just pulled out
cleaned soap particles from door seal area
pressd in new gasket - note orientation
done.
still leaks - will investigate further
cleaned soap particles from door seal area
pressd in new gasket - note orientation
done.
still leaks - will investigate further
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- George from Whitinsville, MA
- Parts Used:
- WP902894
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Leaky door
Removed old gasket and simply replaced it with the new one. Very easy.
Was this instruction helpful to you?
Thank you for voting!