CS30 - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
fuel line leaks
As others have said , simply remove old tank and tubes and replace in reverse order., being sure tube from filter goes to primer bulb.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Irvin from BURR OAK, MI
- Parts Used:
- 308038010
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
bearing set up in lower shaft.
Purchased and replaced curved lower shaft assembly.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- JAE from MILL HALL, PA
- Parts Used:
- 308038010
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
THE DRIVE SPLINE IN THE MIDDLE OF THE SHAFT WOULD NOT ENGAGE
REPLACED LOWER SHAFT
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Herbert from SPANISH FORT, AL
- Parts Used:
- 518777001
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Socket set, Wrench set
Would not run
Replaced carburetor, fuel lines, fuel filter and spark plug all from parts select. Very small amount of carburetor adjustment. Worst part was replacing fuel lines into fuel tank. Sharpened edges and put dawn dishwashing detergent on them and pulled them through tank with needle nose pliers! Worked like a charm!! Spent only about 45 minutes.
Was this instruction helpful to you?
Thank you for voting!