OEM Worx Parts & Accessories

Cutting Head Cover

$4.99

Fix Number: FIX9960988
Manufacturer Part Number: 50006531

This is a single OEM replacement cover for string trimmers. The cover, also sometimes referred to as a cap, works with the spool line assembly to allow line to feed out while trimming, keeping it secure inside the housing. It is common for the cover to wear or crack over time. For this simple repair, press and hold the two latches and pull the cover away from the spool holder. This is a good time to clean all the areas of the cover and spool. Now, to replace this part, press down towards the spool holder to secure the new cover. To ensure it is securely in position, try removing it without pressing down on the latches.

Installation Instructions

Benjamin from DAPHNE, AL

nut on shaft is too large for new cutting head

removed nut from shaft and ground it down so as to fit into new cutting head . the rest was simply snap on. Read more...

Spool & Line

$5.40

Fix Number: FIX9961057
Manufacturer Part Number: 50015034

This is a spool and line for a string trimmer. This is an OEM part, giving you peace of mind that this spool assembly is the correct fit for your model. This pre-wound spool comes with 10-feet of line and is sold individually. For this simple repair, remove the head cover, insert the spool into the cutting head and reinstall the head cover.

Installation Instructions

Benjamin from DAPHNE, AL

nut on shaft is too large for new cutting head

removed nut from shaft and ground it down so as to fit into new cutting head . the rest was simply snap on. Read more...

Cutting Head

$4.99

★★★★★

3 Reviews

Fix Number: FIX11841750
Manufacturer Part Number: 50018883

Installation Instructions

Benjamin from DAPHNE, AL

nut on shaft is too large for new cutting head

removed nut from shaft and ground it down so as to fit into new cutting head . the rest was simply snap on. Read more...

Gear

$8.60

★★★★★

1 Review

Fix Number: FIX11841844
Manufacturer Part Number: 50019119

Fixes these symptoms

Chain will not turn or will not stop turning
See more...

Installation Instructions

Donal from LAKE PARK, FL

Plastic gear needed worn out and replaced

Separate 2 halves of saw shell, remove snap ring from gear, remove gear
Remove motor cover, push axel and gear assembly through bearing. Replace gear reverse steps to reassemble Read more...